1) Slab
[英][slæb] [美][slæb]
铸坯
1.
Effect of slab strain on Nb(C,N) precipitation in continuous casting process
连铸过程铸坯应变对碳氮化铌析出行为的影响
2.
Distribution of non-metallic inclusion quantity in 304 stainless steel slab
304不锈钢连铸坯中的非金属夹杂物数量分布
3.
Effect of cooling rate on the slab surface microstructure of microalloyed steel containing Nb and Ti
冷却速度对含铌、钛微合金钢铸坯表层组织结构的影响
2) casting billet
铸坯
1.
Based on the investigation on the influences of horizontal continuouscasting on the structure and surface of casting billet of BZn15241.
研究了水平连铸工艺对BZn15-24-1 5铸坯组织性能和表面质量的影响,确定了该材料适宜的水平连铸工艺条件,即:铸造温度1200℃～1500℃;拉速45～50m/h;节距8～10mm;频率80～100次/min。
2.
The temperature distribution of continuous casting billet in reheating furnace was measured under practical operation.
在工业生产条件下测量了铸坯加热温度分布,工业试验确定了加热炉经济负荷运行区,建立了推钢式加热炉铸坯加热过程的一维稳态数学模型。
3.
The results show that the equiaxed zone ratio of the casting billet is greatly increased,with its soidification structure is obviously improved,and the momentum values of the electromagnetic forces both parallel to and perpendicular to the direction of the traveling magnetic field pulsate periodically with time.
采用三相通入不同电流的非平衡线性电磁搅拌技术进行了铸坯的静态浇铸实验 ,并对电磁搅拌过程中钢液内的电磁力各分量的瞬时值进行了理论分析·结果表明 ,当采用将电磁搅拌器的三相通入不同电流的非平衡线性电磁搅拌时 ,在钢液内所产生的电磁力是脉动的 ,其大小呈周期性变化 ,尤其是垂直于磁场运动方向上的电磁力 ,其脉动的幅度很大·由此认为 ,当采用将搅拌器的三相通入不同电流的非平衡线性电磁搅拌时 ,所产生的垂直于磁场运动方向上的脉动电磁力是提高等轴晶比率 ,改善铸坯凝固组织的一个重要原
3) billet
[英]['bɪlɪt] [美]['bɪlɪt]
铸坯
1.
Research on Cleanliness of 20MnSi Liquid Steel and Billet in Shuicheng Steel;
水钢20MnSi钢水和铸坯洁净度的研究
2.
Based on electromagnetic theory, an in mold electromagnetic stirrer was built for the billet caster with the strand section of 150 mm by 210 mm.
结合工业试验 ,进行了使用工艺的优化 ,使连铸坯的等轴晶率提高到 4 7% ,铸坯质量有了大幅度提高。
3.
The effect of electromagnetic stirring on the inner quality of the low carbon steel billet was investigated by static casting experiment.
采用低碳钢进行静态浇铸实验 ,并就电磁搅拌对铸坯内部质量的影响进行了实验研究·实验结果表明 ,电磁搅拌可明显提高铸坯凝固组织的等轴晶率 ,同时又可以改善铸坯内的成分分布状况 ,从而提高铸坯的内部质量·在合理的电磁搅拌参数和浇铸参数条件下能够得到几乎为1 0 0 %等轴晶的铸坯
4) casting slab
铸坯
1.
Effect of Casting Slab Defect on Cold Draw Quality of SWRH82B Steel Wire Coil;
铸坯缺陷对SWRH82B钢盘条冷拔质量的影响
2.
The internal quality of casting slab has been improved after optimization for M - EMS.
在铸坯凝固末端安装末端电磁搅拌(F-EMS),通过对末端电磁搅拌器性能参数的检测判定和冶金效果的初步测试并进行生产试验,确定了末端电磁搅拌的电磁工艺参数与搅拌方式。
3.
With the temperature decreasing of casting slab,V starts to precipitate with TiN as nucleation core or nucleate and grow up independently.
实验结果显示,在连铸初期,TiN基本全部从钢中析出,而随着铸坯温度的降低,V开始以TiN为核心或单独形核析出,在铸坯均热后,大部分单独形核的V(C,N)趋于溶解,未溶解的则开始长大,而以TiN为核心的(Ti,V)(C,N)中的V部分溶解于钢中,V在粒子中的含量减少。
5) bloom
[英][blu:m] [美][blum]
铸坯
1.
Effects of mold powder property on 12Mn2VB steel bloom surface quality;
结晶器保护渣性能对12Mn2VB钢连铸坯表面质量的影响
2.
Based on the research,it was found that center segregation especially carbon segregation in blooms was the major prob-lem.
通过研究,发现铸坯中心偏析尤其是碳偏析为主要问题。
3.
In order to improve the quality of round blooms,based on technical parameters of round bloom continuous caster at Ma anshan Iron and Steel Co.
为提高圆坯质量,基于马钢圆坯连铸机技术特点,采用Gleeble2000热模拟试验机研究了代表钢种圆坯高温力学性能,通过理论分析和试验研究建立了二冷工艺模型,并分析了结晶器电磁搅拌参数对铸坯质量的影响。
6) cast slab
铸坯
1.
The article introduces the basic principle to realize the quality improvement of continuous cast slab using multipoint straightening technique and the reasonable control of strain distribution and rate;also offers the number of straightening points,radius of curvature Ri,straightening strainεi and calculation method of strain rate.
分析采用多点矫直法,合理控制应变分配及应变速率,提高连铸坯质量的基本原理。
2.
Utilizing the methods of sample-electrolysing,metallographic observation,SEM and EPMA,the quantity,dimension,morphologies and composition of non-metallic inclusions in X70 pipeline steel cast slab were investigated.
利用大样电解、金相观测、扫描电镜(SEM)和电子探针(EPMA)等手段,对X70管线钢铸坯中夹杂物的数量、粒径、形貌及组分进行了研究。
补充资料：连铸坯
continuouscastingbillet：连续铸钢生产的坯料。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条