1) Joint strength
接头强度
1.
The influences of welding heat input on joint strength were analyzed.
采用钨极氩弧焊的方法对30%SiCP/LD2高体积分数复合材料进行了焊接实验,研究了在同种TIG焊焊接规范参数下LD2-LD2、LD2-30%SiCP/LD2、30%SiCP/LD2-30%SiCP/LD2三种不同材料组合焊接性差异,分析了焊接热输入对接头强度的影响。
2.
The experimental results show that for industrial purity Ti and Ti 6Al 4V, respectively, the overlap brazing joint strength are 418.
结果表明:用Ti-Cu-Ni钎料钎焊TA2和Ti-6Al-4V钛合金的搭接接头强度分别是418。
3.
The temperature and time range of brazing through the wetting experiment were confirmed, and the effect of brazing conditions on the joint strength through the shear experiment was discussed.
通过对钎料润湿性的研究确定钎焊试验的温度和时间范围 ;通过剪切试验研究了钎焊工艺参数对接头强度的影响。
2) strength of joint
接头强度
1.
Effect of interfacial microstructure of TiAl/40Cr diffusion bonding on strength of joint;
TiAl/40Cr钢扩散连接界面组织结构对接头强度的影响
3) bonding strength
接头强度
1.
The bonding strengths of joints were evaluated by shear test, and the fracture paths of joints were analyzed by SEM,EPMA and XRD.
8ks的连接条件下，当连接时间较短时接头强度较高，如室温时为240MPa，高温（973K）时为230MPa，接头在（Ti5Si3CX＋TiC）／TAD界面处断裂。
2.
The factors affecting the bonding strength of the joints in transport conveyer belt is analyzed, the bonding technique is introduced, and measures of improving the maintenance quality of the belt are put forward so as to extend its service life.
分析影响运输皮带胶接接头强度的因素,介绍运输皮带的胶接工艺,提出提高皮带维修质量的措施,延长皮带使用寿命。
4) strength of welded joint
焊接接头强度
1.
An approach to evaluate the strength of welded joints with mechanical heterogeneity was proposed.
提出一种评价力学性能不均匀焊接接头强度的方法。
5) butt joint strength
接头(接口)强度
6) joint shear strength
接头剪切强度
1.
Influences of the metallizing technologic conditions, Ni plating and subsequent annealing on the joint shear strength were investigated.
考察了金属化工艺、镀镍及镀后热处理对接头剪切强度和钎焊效果的影响。
补充资料：表光合强度(见光合强度)
表光合强度(见光合强度)
forecast of sowing or transplanting time
b iaoguanghe qiangdu表光合强度见光合强度
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条