1) minimum chip thickness
最小切削厚度
1.
In micro-cutting,a chip will not be generated if the uncut chip thickness is less than a critical value,viz,the minimum chip thickness.
最小切削厚度是微切削中产生切屑必须超过的切削厚度的临界值。
2) cutting depth
切削厚度
1.
The relationship between sheer stresses and cutting depth is found.
利用位错理论对超声波振动切削过程中剪切应力进行分析 ,从微观方面得出其计算公式 ,发现剪切应力与切削厚度的关
3) undeformed chip thickness
切削厚度
1.
Influences of the double negative chamfer angles of diamond turning tool and the undeformed chip thickness on the surface rolling effect are analyzed, and the empirical formulas of surface rolling rate are presented.
对汽车轮毂抹平加工的主要工艺参数进行了试验研究 ,分析了金刚石抹平车刀双重负倒棱角度和切削厚度对抹平效果的影响 ,给出了抹平率经验公式。
4) Cutting thickness
切削厚度
1.
Study on the effects of cutting thickness of bamboo on its cutting quality;
切削厚度对竹材刨切质量影响的研究
2.
Aiming at the helical ball-end milling tool used in HSM,the milling force model of tool infinitesimal was built up,then the calculation method of instantaneous cutting thickness was presented,finally,a new whole milling force model was obtained by integral.
针对高速铣削中广泛应用的螺旋刃球头铣刀建立刀具微元的铣削力模型,给出了瞬时切削厚度的计算方法,通过积分得出了一种新的整体铣削力模型。
3.
The new method of cutting thickness analysis and compute is given out.
介绍了插齿时产生齿面挤伤及插齿刀后面非正常磨损的特有现象,分析了其原因以及切屑的几种形态,给出了切削厚度分析计算的新方法,提出一套新见解和解决措施。
5) minimum cutting depth
最小切削深度
1.
To probe into machining mechanism in micro cutting,the minimum cutting depth for achieving stable machining was discussed.
为探讨微切削的加工机理,对能稳定切削的最小切削深度进行了研究。
6) minimum cutting force
最小切削力
补充资料：最小辐亮度与最小辐照度(见核爆炸火球)
最小辐亮度与最小辐照度(见核爆炸火球)
minimum-brightness and minimum-irradiance
zuixiao fuliangdu yu zuixiaofu乙haodu最小辐亮度与最小辐照度(minimum-brightness and而nimum一irradianee)见核爆炸火球。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条