Study on forming capacity of the form-electrolyte for dielectric Al anodic oxide film;

Finite element simulation for tube hydroforming process and analysis of failure mode;

Dynamic analysis and hydroforming mould design for motorcycle oil box;

A new model of sheet metal hydroforming equipment based on a type YX28-400/650C double-action press;

The study of loading path optimization for tube hydroforming process;

Based on some of the research results of the authors,the influence of the weld properties on tube hydroforming .

To study the effect of process parameters on the hydroformed T-shaped tubular parts, a new criterion to estimate the formability of T-shaped tube hydroforming is proposed.

Research on hydroforming of square parabolic reflector;

Optimization for hydroforming blanks of a car beam based on the Grey system theory

A device for hydroforming is introduced briefly By experiments,the effects of blank holding force and chamber pressure on forming of truncated conical parts with hydraulic counter\|pressure deep drawing are investigated and the parts of large drawing ratio are obtained in single step by using this drawing metho

Warm hydroforming process of lightweight alloys;

Using a length of tube as the blank, hydroforming technology of tubular parts promise an extensive prospect to produce a variety of complex hollow components.

This paper presents the principle, advantages and typical application of internal high pressure forming (IHPF), sheet hydroforming, warm hydroforming and shell hydroforming.

The appliction of computer simulation to material forming technology,as well as its study range and methods,present status in liquid forming,plastic forming and joint forming are reviewed and the future development direction is analysied.