1.
Numerical Simulation for the Hydroforming Processes of Tubular Parts;
管壳零件轴压液力成形过程的数值模拟
2.
Prediction of Defects in Tube Hydroforming Based on Forming Stress Limit
基于成形应力极限的管材液压成形缺陷预测
3.
Effect of Hemodynamics on Pathogenesis of Abdominal Aortic Aneurysms;
腹主动脉瘤形成机制中血液动力学作用
4.
Study on Glass-Forming Ability and Liquid Fragility of Bulk Metallic Glasses;
大块非晶合金玻璃形成能力与液体脆性的研究
5.
Experiment method on mechanism of thrust of laser-induced ablation propulsion with liquid propellant
液体烧蚀激光推进推力形成机理实验方法
6.
The Study on the Effect of NaCl on the Formation and on the Solubilization Gibbs Free Energy in Microemulsion System
氯化钠对微乳液形成及增溶热力学的影响
7.
Effect Of Blood Cell Components On Aerobic Capacity Of Soccer Player
血液有形成分对足球运动员有氧能力的影响
8.
Investigation on the Mechanical Modelling and FEM Simulation of Dynamic Transition from Liquid to Solid in Liquid-solid Forming under High Pressure;
液固高压成形中液固相连续转变的力学建模及有限元模拟研究
9.
In these methods mechanical agitation or high pressure are usually used, which cost too much energy and can't get uniform liquid droplets Membrane emulsification is one of the best methods to prepare emulsion.
这种方法所需压力很小，形成的液滴直径均一，并能形成不同粒径的乳液，是理想的制乳方法。
10.
Predicted the Formative Tendency of Pinholes in Gray Cast Iron and Graphite Shape of Cast Iron by Making Use of Surface Tension of Liquid Cast Iron
利用铁液表面张力炉前快速预判铸铁针孔形成倾向性及石墨形态
11.
hydrauliccone-bolt coupling
液力锥形螺栓联轴器
12.
The process of forming and falling in drops.
形成液滴和滴落的过程
13.
Analysis and Calculation of Forming Pressure for Aluminium Alloy Shock Absorber Tube of Motorcycle by Liquid Extrusion
摩托车铝合金减震筒液态挤压成形压力的分析及计算
14.
Study of Motion and Transfer Heat Process of Droplet and Stress of Billet;
喷射成形液滴运动和传热过程及沉积坯的应力研究
15.
The severed fluid may form a drop or may form an unstable ligament which will later break up into drops.
分裂的流体可以形成液滴，或者形成不稳定的液带，随后破裂成液滴。
16.
The Effect of Huoxue Huangjiang on Athlete s Parameter of Blood Dynamics and Rheology and Blood Tangible Composition;
活血皇浆对田径运动员血液动力流变学和血液有形成分参数的影响
17.
Forming Study and Process Control of the Multi-tube's Hydroforing;
多通管液压胀形成形研究及过程控制
18.
Study on Hydraulic Pressure Bulge Forming Theeory and Experiment of Thin Tube;
薄壁管液压胀形成形理论及试验研究