1) valve type orifice system
配流系统
1.
A multi-objective optimization model of valve type orifice system of hydraulic confined piston engine was built.
建立了液压约束活塞发动机配流系统的多目标优化模型,采用复合形法进行了优化研究。
2) valve type orifice system
阀式配流系统
1.
The concept of Hydraulic Confined Piston Internal Combustion Pump(CPICP)and its working principle are put forward,also the dynamic analysis of the valve type orifice system is made.
提出了约束活塞型内燃式水泵的概念和它的工作原理,对其阀式配流系统进行了动力分析。
2.
The dynamic equation of valve type orifice system of confined piston internal combustion pump was built.
提出约束活塞型内燃式水泵的概念并阐述其工作原理,建立了阀式配流系统的动力模型。
3) plate
配流
1.
A new type of water pump with piston plate is presented.
讨论了端面配流水压泵、阀式配流水压泵结构特点以及应用情况,对国内外的研究成果进行综合分析,在此基础上,提出了柱塞配流这种新型配流方式的水压泵,并从其结构入手,着重研究了柱塞配流泵工作原理的可行性,指出该泵在理论上重点研究的方向。
4) Manifold
分配流道
5) allocation for health funds
分配流向
1.
Health accounting can be classified three levels, they are health finances from initial sources, allocation for health funds and health funds final use.
卫生总费用测算涉及到卫生资金的筹集来源、分配流向(即机构流向)和使用消耗三个不同层次。
6) Port plate
配流盘
1.
This paper proposes a new form of variable vane pump, semi-cone damping groove, and discusses the advantages and machining methods of semi-cone damping groove as well as studies the design of variable vane pump port plate by semi-cone damping groove.
研究了使用抛物线母线的半圆型减振槽变量叶片泵配流盘的设计方法。
2.
Cavitation mechanism of a port plate is .
针对实验中轴向柱塞泵出现的空蚀破坏,对轴向柱塞泵配流过程进行计算流体动力学(CFD,computational fluid dynam ics)解析,得到了配流盘不同位置的速度分布和压力、速度随缸体转角的变化曲线;得出轴向柱塞泵空蚀破坏的机理———空蚀破坏不仅取决于减压槽附近的速度和压力大小,还取决于速度的方向;并且指出如果减压槽处的射流角大小在30°~65°范围内高压轴向柱塞泵就不容易产生空蚀破坏的问题。
3.
The research shows that the output pressure of the HT depends on the control angle of the port plate and is influenced by loads.
仿真与试验结果吻合,液压变压器输出压力由配流盘控制角度θ决定,同时受负载的影响。
参考词条
补充资料：流配
1.把犯人发配到边远地方。 2.指被发配到远地的犯人。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。