2) extrusion simulation
挤压模拟
3) Simulating extrusion
模拟挤压
4) hot extruding die
热挤压模
1.
Base on orthogonal test and using engineering average effect analysis method,the best process parameters of sulphonitrocarburizing for the H13 steel hot extruding die was determined.
用正交试验和工程平均效应分析方法确定了H13钢铝型材热挤压模的工作面 (俗称“窄缝面”)进行硫氮碳三元共渗的最佳工艺参数。
5) hot extrusion die
热挤压模
1.
3D coupled thermo-mechanical analysis and optimal design of hot extrusion die for polygonal aluminum profile
多边形铝型材热挤压模三维热力耦合分析与优化设计
2.
The application of chromizing after carburizing for hot extrusion dies used for shaping aluminium showed that its service life is m.
将渗碳、渗铬工艺应用于H13钢铝型材热挤压模,模具使用寿命比渗氮模具提高50%以上,型材表面光洁度得以提高。
3.
The hot extrusion dies of polygon aluminum profile from a aluminum profile factory were studied with the method of 3D thermal-mechanical coupled analysis based on the theory of limited distortion.
以某铝型材加工厂的多边形铝型材热挤压模具为研究对象,对其进行了基于有限变形理论的三维热力耦合分析,找出了引起分流桥产生裂纹的原因是模具结构不合理导致应力分布不均,局部应力集中严重。
6) hot extrusion die
热挤压模具
1.
Three-dimensional coupled thermal-mechanical numerical analysis of hot extrusion dies;
热挤压模具热力耦合三维数值分析
2.
Application of B2 steel on hot extrusion die;
B2钢(4Cr2MoVNi)在热挤压模具上的应用
3.
This article introduces service condition and failure characteristic of hot extrusion dies made of 3Cr2W8V steel,and analyzes heat treatment process of dies,gives idea on how to improve processing measure also.
介绍了3Cr2W8V钢热挤压模具的使用条件及失效特征,分析了该模具的热处理工艺,并提出了工艺改进方案,有效地延长了热挤压模具的使用寿命。
补充资料：冲击挤压(见冷挤压)
冲击挤压(见冷挤压)
impact extrusion
ehongji jiya冲击挤压(impaet extrusion)见冷挤压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条