1) isothermal-rolling
恒温轧制
1.
The outline of superplastic and anisotropic behavior in AZ91D grain refined by isothermal-rolling is summarized comprehensively.
本文综合评述了日本目前对恒温轧制微细化AZ91D板材的超塑性及其各向异性的研究情况。
2) constant temperature and toughness rolling
恒温韧性轧制
1.
The new process of constant temperature and toughness rolling of electroslag remelted ingot of GH4049 after high temperature homogenization was studied.
本文研究了GH4049合金电渣锭高温均匀化后采用恒温韧性轧制新工艺,减少了轧制火次,改善了表面质量,有效地提高了生产效率和成材率。
3) constant speed rolling
恒速轧制
4) constant-tension rolling
恒张力轧制
5) thermostatic control
恒温控制
1.
Application of thermostatic control module in opacimeter;
恒温控制模块在不透光烟度计中的应用
2.
inspection,analysis,exclusion,especially focusing on problems happened in the thermostatic control system,washing water circulation system etc.
本文从柯达1140-L型胶片冲洗机的电路基本工作原理入手,介绍了怎样利用观察法、分析法和排除法等方法对该机出现的常见故障进行检修,尤其是恒温控制系统、水洗循环系统等方面的问题。
3.
However, the measuring systems of insulating oil dielectric loss and volume resistivity used at present exist the shortcoming of low accuracy, weak repeatability, inconvenience, and its thermostatic control system can t meet the challenge.
对油介损及体积电阻率测量时，首先要在15分钟内将油温从室温升到90℃并保持恒定，因此对恒温控制系统要求较高。
6) constant temperature control
恒温控制
1.
Research on constant temperature control system based on neural network;
基于神经网络的恒温控制系统的研究与设计
2.
The Design of Constant Temperature Controller Based on Infrared Heats up;
基于红外加热的恒温控制器的研制
3.
The design of constant temperature control system in laboratory by using single chipmicrocomputer;
用单片机对实验室恒温控制系统的设计
补充资料：恒温过程
分子式：
分子量：
CAS号：
性质：见等温过程。
分子量：
CAS号：
性质：见等温过程。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条