1) Impact energy
冲击功
1.
Investigation on the correlation between fracture toughness and impact energy for middle strength steel;
中强钢断裂韧性和冲击功关系的研究
2.
Comparison of two kinds of models to predict the impact energy of the hot rolled Q235B in MaGang;
Q235B热轧板冲击功人工神经网络与线性回归预报模型的比较
3.
The results show that the impact energy increases and the yield strength decreases slowly with increasing the tempering temperature in the range of 200～600 ℃,and the impact energy increases and the strength decreases sharply when the tempering temperature is increased to above 600 ℃.
结果表明,25CrNi3MoV钢在200-600℃范围内回火时,随回火温度的升高,屈服强度缓慢下降、冲击吸收功缓慢增大;600℃以上回火时,强度急剧下降、冲击功迅速升高。
2) Impact work
冲击功
1.
The Un -qualified Reason Analysis of the Impact Work for Grade 35 Steel Forging Used for Pump Shaft;
35钢泵轴锻件冲击功不合格原因分析
2.
The linear relation between crushing specific work and the impact work and the temperature of ice.
研究冰在冲击载荷作用下发生破碎的状态，提出破碎比功的概念，分别建立了破碎比功与温度和冲击功的线性表达式。
3.
The results show that for the samples with remaining casting microstructure after normalizing,its tensile strength and elongation can be up to standard,and its fracture contraction rate reduces a little,but its impact work becomes lower than the samples with normal microstructure.
结果表明,正火不充分而残留铸态组织的铸钢试样,抗拉强度、伸长率均能达标,断面收缩率稍低,但冲击功却比正常组织试样低很多。
3) impact power
冲击功
1.
Influence of impact power on impact-corrosion resistance of low carbon high alloy steel;
冲击功对低碳高合金钢冲击腐蚀磨损性能的影响
2.
The property of impact-corrosion resistance of the low-carbon hi-alloyed steel has been tested in different impact power with the reconstructive impact-corrosion resistance machine.
利用改造的冲击腐蚀磨损机,测试了不同冲击功下低碳高合金钢的冲击腐蚀磨损性能。
3.
The results indicate that although the impact frequency of DTH hammer decreased somehow, the impact power increased.
结果冲击频率虽然有所下降 ,但其冲击功却有升高的趋势。
4) impacting energy
冲击功
1.
34 m/s, and the single impacting energy has reached 346.
43m/s) ,单次冲击功 34 6 。
2.
The impacting energy and impacting frequency of hydro-efflux hammer are two important indicators to measure the level and quality of hydro-efflux hammer.
射流冲击器的冲击功和冲击频率是衡量射流冲击器水平与质量的2个重要指标。
5) Impact energy Ak
冲击功Ak
6) high impact energy
高冲击功
补充资料：髯口功
| 髯口功 中国戏曲表演基本功。戏曲人物所戴的假须，统称髯口。戏曲表演中，常借助舞弄髯口的动作来展示人物的心情，俗称耍髯口。耍髯口的技巧有搂、撩、挑、推、托 、摊、捋、抄、撕、捻、甩、绕、抖、吹等多种，其中有些是单项动作，有些可以组合一起连贯使用，必须与舞蹈身段密切配合，才能表达人物的思想情绪，如搂髯多用于昂首观望与低头俯视；撩髯多表现思忖和自叹；推髯多反映慨叹；捋髯多展示安闲；抖髯多用于惊怕；吹髯则反映生气等。
|
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条