2) 304 stainless steel
304不锈钢
1.
A Study on Non-Metallic Inclusion in 304 Stainless Steel Produced by Twin Roll Thin Strip Casting;
双辊薄带连铸304不锈钢中非金属夹杂物研究
2.
An Analysis on Formation and Distribution of Cracks in 2mm 304 Stainless Steel Concasting Thin Strip;
304不锈钢2mm连铸薄带中的裂纹分布和形成分析
3.
Study on corrosion resistance of bright annealing treated 304 stainless steel in NaCl solutions;
光亮退火处理304不锈钢在NaCl溶液中的耐蚀性
3) stainless steel 304
不锈钢304
1.
The wear of reamers made of three kinds of material,which are stainless steel 304,high speed steel(W18Cr4V) and Cr12,under different conditions was studied.
用表面形貌仪,采用平行试验方法,研究FL150型风冷式粉碎机粉碎手机边框板在常温和低温2种条件下,不锈钢304刀具、高速钢(W18Cr4V)刀具、Cr12刀具3种材料刀具的磨损情况。
4) Stainless Steel
304不锈钢
1.
Numerical Simulation of Temperature Field of 304 Stainless Steel Rod and Wire Hot Continuous Rolling;
304不锈钢棒线材热连轧温度场的数值模拟
2.
Effect of Secondary Cooling Water Rate on Concasting Slab Quality of 304 Stainless Steel;
二冷配水对304不锈钢连铸板坯质量的影响
3.
The corrosion behavior of 304 stainless steel and its corrosion protection by organic silicone coatings with Al powder and Ti powder in the presence of a pre-deposited solid NaCl and water vapor at 400℃ was studied.
研究了304不锈钢在400℃、盐和水蒸气综合作用下的腐蚀行为及添加Al粉和Ti粉的有机硅涂层对不锈钢的防护作用。
5) type 304 stainless steel
304不锈钢
1.
After a specimen of type 304 stainless steel was pre-crept at a constant load in silicon oil at 143℃ for 24 h, and underwent stress corrosion cracking (SCC) at the same constant load in a MgCl2 solution at 143℃ at open-circuit potential for 2 h, α' martensite on the surface and over the entire specimen increased 14% and 1.
304不锈钢在143℃硅油中恒载荷预蠕变足够长时间后,再在143℃ MgCl2溶液中相同恒载荷下进行应力腐蚀。
6) Carbon-304 Stainless-Carbon Steel Clad Plate
碳钢304不锈钢碳钢复合板
补充资料：[3-(aminosulfonyl)-4-chloro-N-(2.3-dihydro-2-methyl-1H-indol-1-yl)benzamide]
分子式：C16H16ClN3O3S
分子量：365.5
CAS号：26807-65-8
性质：暂无
制备方法：暂无
用途：用于轻、中度原发性高血压。
分子量：365.5
CAS号：26807-65-8
性质：暂无
制备方法：暂无
用途：用于轻、中度原发性高血压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条