1) 540 MPa hot rolling dual phase steel
540MPa级热轧双相钢
2) as-hot rolled dual-phase steel
热轧双相钢
1.
Relationship between microstructure and mechanical properties of C-Si-Mn as-hot rolled dual-phase steel;
C-Si-Mn系热轧双相钢显微组织与力学性能之间的关系
2.
It is found that cooling rate has an great effect on the microstructure and mechanical properties of as-hot rolled dual-phase steel.
通过实际的热轧实验,研究了轧后冷却速度对C-Si-Mn系热轧双相钢组织形貌和力学性能的影响。
3) hot rolled dual phase steel
热轧双相钢
1.
Based on the orthogonal design, this paper has investigated the effects of four technological parameters (final rolling temperature, degree of final deformation, quenching temperature, cooling time after final rolling) on martensite volume fraction of hot rolled dual phase steel in single sheet.
在正交实验的基础上，采用方差分析方法研究了４个工艺参数（终轧温度、终轧变形量、淬火温度、轧后缓冷时间）对单张热轧双相钢马氏体体积分数的影响。
2.
The development of DP600 hot rolled dual phase steel of Bengang was introduced.
分析双相钢的组织特点和生产工艺,介绍本钢DP600级热轧双相钢的开发,具体阐述了工艺条件对C-S i-Mn-Cr-Mo系双相钢组织性能的影响及工艺参数的确定。
4) hot-rolled dual-phase steel
热轧双相钢
1.
The effect of various tempering tempertures on the microstrucure of a hot-rolled dual-phase steel has been investigated in this paper.
研究了热轧双相钢Ｆｅ—０。
2.
According to the alloying mechanism of hot-rolled dual-phase steel and referring to the chemical composition of foreign and domestic products,a composition without Mo (but including B) is suggested for this steel grade.
据热轧双相钢的合金化原理,并参照国内外热轧双相钢的化学成分,提出了无钼(含硼)热轧双相钢的化学成分。
5) hot-rolling-two-phase steels
热轧-双相钢
6) As-hot-rolled dual-phase steel
热轧态双相钢
补充资料：[3-(aminosulfonyl)-4-chloro-N-(2.3-dihydro-2-methyl-1H-indol-1-yl)benzamide]
分子式：C16H16ClN3O3S
分子量：365.5
CAS号：26807-65-8
性质：暂无
制备方法：暂无
用途：用于轻、中度原发性高血压。
分子量：365.5
CAS号：26807-65-8
性质：暂无
制备方法：暂无
用途：用于轻、中度原发性高血压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条