1) work holding arbor
工件心轴
3) part axle
工件轴
1.
Improvement of chucking method and part axle of 3MZ3210 super lapping machine
3MZ3210超精研机夹紧方式及工件轴的改进
4) Shafts
[英][ʃɑ:ft] [美][ʃæft]
轴类工件
1.
The Development of the On-line Straightness Detection System for Shafts
轴类工件直线度在线检测系统的开发
5) hollow shaft parts
空心轴类件
1.
However,researching on the process of CWR of hollow shaft parts is mainly to take use of experiments,even using finite element method is really few and scattered without systemic analysis.
人们对空心轴类件楔横轧过程的研究大多采用实验的方法,即使采用有限元理论也是非常零碎的,并未系统地研究空心轴类件的楔横轧过程。
6) Eccentric workpiece
偏心工件
1.
The eccentric definition of the workpiece was described,using the three-jaw chuck processing eccentric workpiece thickness pads eccentricity e,x and the relationship between the eccentric workpiece machining methods and processing eccentric workpiece prone to the problems and needs the attention of.
叙述了偏心工件的定义,说明了用三爪卡盘加工偏心工件时垫片厚度x与偏心距e间的关系,偏心工件的加工方法及加工偏心工件时容易出现的问题和需要注意的事项。
补充资料：在AutoCAD中偏心圆锥与偏心圆台实体的画法
现在要画一个偏心圆锥,底面在WCS的XY平面上,圆心(0,0,0),半径100,顶点(300,0,400)在ZX平面上.
1)连接PA,PB. A(-100,0,0) B(100,0,0)
图1
在当前坐标下:
2)延长PA到C,使PA=CA;延长PB到D,使PB=DB;
3)连接CD;
4)以CD为直径画圆;
5)用XLINE命令中的二等分选项作角CPD的角平分线PO,交CD于O;
6)过O作CD的垂线,交圆于E,F;
图2
7)用三点UCS命令,取三点为:O,P,C;
8)过点O作PO的垂线GO,交PC于G;
图3
9)再次用三点UCS命令,取三点为O,F,G;
10)现在就可以画椭圆锥了!
cone-e-c-捕捉O点-捕捉F点-捕捉G点-a-捕捉P点;
图4
11)回到WCS,剖切椭圆锥
SL-选择椭圆锥-回车-XY-回车-捕捉P点.
12)删除辅助线条.
图5
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条