1.
A Species of Simple Equipment Manufacturing Non-concentric Turnery in Plain Lathe;
普通车床上车削偏心工件的简易装置
2.
A Precise Algorithm for the Relative Depth of Compressive Zone about The Compression Member with Small Eccentricity in Bridge Engineering
桥梁工程中小偏心受压构件相对受压区高度的精确计算方法
3.
Research on Application of Center Bore in Multi-eccentric Shaft Processing
中心孔在多偏心轴加工中的应用研究
4.
a parochial person, attitude, event
心胸狭隘的人、 偏狭的态度、 地方事件
5.
Reliability analysis of RC members subjected to eccentric compression based on random characteristics of eccentricity
基于偏心距随机特性的混凝土偏心受压构件可靠度分析
6.
Heat Treatment for ZG25MnCrNi Steel Castings with Segregated Structure
ZG25MnCrNi钢组织偏析铸件的热处理工艺
7.
Work Analysis on Partial Wheel-brake Type Broken Belt Protector
偏心轮闸块式断带抓捕器的工作分析
8.
Discussion on the Computational Methods of Eccentricity Magnification Coefficient of Eccentric Compression Reinforced Concrete Members
钢筋混凝土偏压构件偏心矩增大系数计算方法探讨
9.
This method used to machining permitting no positive deviation.
此方法适用于加工不允许有正偏差的工件。
10.
eccentric sheave
偏心内轮偏心皮带轮
11.
Sand-belt grinding process applied to grinding the eccentric shaft of mining crusher
砂带磨削在破碎机偏心轴加工工艺上的应用
12.
DISCUSSION ON CRACK CONTROL OF ECCENTRICALLY TENSIONED PRESTRESSED MEMBERS
预应力偏心受拉构件裂缝控制方法的探讨
13.
Electro-hydraulic Servo Edge Position Control Technology with Low Energy Lose and Key Devices Redundancy
核心器件冗余的低能耗电液伺服纠偏控制技术
14.
BEHAVIOUR OF HIGH-PERFORMANCE CONCRETE FILLED STEEL TUBULAR COLUMNS SUBJECTED TO ECCENTRIC LOADING
钢管高性能混凝土偏心受压构件力学性能研究
15.
Vehicle Sideslip Angle Estimation Under Extreme Driving Condition
极限行驶条件下车辆质心侧偏角观测器设计
16.
Study on Technology Analysis Software of Power Spinning and Spinning Force and Offset Loading Force;
强力旋压工艺分析软件及旋压力和偏载力研究
17.
The Research on Detection Technology of Deviating in the Deep-hole Processing of Engine Parts
发动机零件深孔加工走偏检测技术研究
18.
Construction for Entrances and Exits Shallow Burying Section under Bias Voltage Condition in Paotongping Tunnel
泡桐坪隧道进出口浅埋段偏压条件下施工