1) tube in-shell heat exchanger
壳管式热交换器
2) shell and tube type heat exchanger
管壳式热交换器
3) shell-and-tube heat exchanger
管壳式热交换器,表面式热交换器,管壳式换热器
4) tubular heat exchanger
管壳式换热器
1.
Loads analysis of anchor bolts of a horizontal tubular heat exchanger;
卧式管壳式换热器地脚螺栓受力分析
2.
The Estimate of Heat Exchange Tubes Number in the Tubular Heat Exchanger;
管壳式换热器换热管根数的估算
3.
Thermoeconomic design of tubular heat exchanger;
管壳式换热器的经济学优化设计
5) shell and tube heat exchanger
管壳式换热器
1.
The Direction and Development of shell and tube heat exchanger;
管壳式换热器的研究进展与方向
2.
A Study on the Local Void Fraction at the Shell Side of No-Leak Shell and Tube Heat Exchangers;
无泄漏的管壳式换热器壳侧局部含气率的研究
3.
Evaluation methods to heat transfer enhancement performance in shell of shell and tube heat exchanger;
管壳式换热器壳程强化传热评价方法分析
6) shell-and-tube heat exchanger
管壳式换热器
1.
Investigation in baffle-rod support on shell-and-tube heat exchanger;
管壳式换热器杆式支撑结构的研究与应用
2.
Analysis of the transient heat transfer performance of shell-and-tube heat exchangers;
管壳式换热器瞬态换热性能分析
3.
The Existing Problems in Design and Operation of Shell-and-Tube Heat Exchanger;
管壳式换热器设计和运行中存在的问题分析
补充资料:板翅式热交换器(platewingheatexchanger)
板翅式热交换器(platewingheatexchanger)
铝制板翅式热交换器是在数层平金属板之间紧密地放置波纹状的金属导热翅片,并在每一层的四周加上封条,于温度近600℃的盐溶液炉中整体铅焊而成。翅片的主要作用是强化传热,也有增强两金属板强度的作用,在这种热交换器中相邻两通道之间的热交换,一部分通过平板传递热量,但绝大部分热量是通过波纹翅中传递的,因为平板之间均有波纹翅片,因而大大增加了传热面积,所以它的单位体积内的传热面积比一般管式热交换器大10倍以上,达到4000~5000m2/m3。通过各通道之间的不同组合,可得到逆流、错流等形式的热交换器。它具有单位体积传热面积大、传热效率高、流体阻力小、热容量小、结构紧凑及同时允许几种介质进行热交换等优点。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条