说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 圆函数;三角函数
1)  circular function
圆函数;三角函数
2)  elliptical triangle functions
椭圆三角函数
1.
The definition of elliptical triangle functions is given and ordinary triangle functions are generalized.
对普通三角函数进行了推广,给出了椭圆三角函数的定义,指出椭圆三角函数是周期函数,存在最大值和最小值,并在定义域内连续可导。
3)  Trigonometric function
三角函数
1.
The Trigonometric Function Method for Symmetrical Bending of Cantilever Rectangular Plates;
悬臂矩形板对称弯曲的三角函数解法
2.
Determination of optimal power of data fitting to characteristic curve of trigonometric function;
三角函数曲线数据拟合最佳次数的确定
3.
Generalization of a Definite Integral Formula about Trigonometric Function;
一个三角函数积分公式的推广
4)  Triangle function
三角函数
1.
In this paper,a method of approach to curve & Surface modelling based on triangle function is proposed,which has the principal merits of B-Spline and achieres a C 3 curve.
本文提出了一种基于三角函数的拟合方法 ,它具有B样条的主要优点 ,并达到C3级连续 ,因此 ,这一方法适用于自由曲线曲面的设计。
2.
In this paper,using partially the method of Majorization,we give the supremum and infimum of the triangle function of (k) = ∑sink A - ∑ cosk A(k=3, 5
通过局部地采用优超方法给出了三角函数(k)=∑sinkA-∑coskA(k=3,5)的上下确
3.
This paper discusses an algebraic property of values of rational degrees of triangle functions.
本文讨论了三角函数在有理度数上的取值的代数性质,得出其取值均为代数数。
5)  trigonometric functions
三角函数
1.
Class of quasi-cubic parametric curves based on trigonometric functions;
一组基于三角函数的类三次参数曲线
2.
These ways include the use of simultaneous equations, trigonometric functions and computer aided drawing software.
本文介绍了有直线和圆弧组成的零件轮廓的基点计算的有效方法,这些方法包括联立方程组法、三角函数法 和计算机绘图软件法。
3.
This paper gives a general equivalent infinitesimal of trigonometric functions,and utilizes the equivalentinfinitesimal to make questions become easy.
给出了三角函数的一般形式的等价无穷小,并利用等价无穷小,来简化求极限时繁琐的步骤。
6)  triangular function
三角函数
1.
The measurement of the efficient depth with triangular function in breast cancer isocenter irradiation orientation;
利用三角函数定位法测定乳腺癌放疗的有效治疗深度
2.
This paper presents the methods of triangular function for Fitting arbitrary curves.
本文详细讨论了一种基于三角函数的拟合方法 ,它具有B样条的主要优点 ,达到C3连续 ,而三次B样条只能达到C2 连续。
3.
For each j and σ,n generalised triangular functions and m generalised hyperbolic functions are,respectively,introduced,some properties of them are discussed and some important formulas are given.
相应于每个这样的j和σ,分别引入了n个推广的三角函数和m个推广的双曲函数,然后讨论了它们的性质并给出了有关的重要公式。
补充资料:圆函数

圆函数

亦称三角函数.是正弦、余弦、正切、余切、正割、余割等函数的总称。在平面上直角坐标系oxy中,与x轴正向夹角为α的动径上取点p,p的坐标是(x,y),op=r,则正弦函数sinα=y/r,余弦函数cosα=x/r,正切函数tanα=y/x,余切函数cotα=x/y,正割函数secα=r/x,余割函数cscα=r/y。历史上还用过正矢函数versα=r-x,余矢函数coversα=r-y等等。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条