1) film thickness
油膜厚度;膜的厚度
2) lubricant film thickness
油膜厚度
1.
This paper had got overall introduction on many measurement technologies and detecting methods of lubricant film thickness, and on their disadvantages and application status in that of thrust bearing.
较为全面、系统地介绍了润滑油膜的测量技术和各种检测方法的特点与不足,以及在推力轴承检测中的应用情况,这对于更好地进行推力轴承油膜厚度的检测有一定的参考价值。
3) oil film thickness
油膜厚度
1.
The influence of oil film thickness variation on workpiece gauge control in rolling process is analyzed.
分析了轧制过程油膜厚度变化对钢板厚度控制精度的影响,基于油膜厚度Reynolds计算公式,借鉴轧辊调零计算轧机弹跳的想法,提出相对油膜厚度的计算方法,并在轧机上进行数据采集,得到油膜变化的实测值,通过弹跳曲线的平移处理,得到最终的油膜变化曲线,根据该曲线可很方便地确定模型的结构并拟合出模型系数。
2.
In order to analyze the influence of oil film thickness of back-up roll dynamic oil film bearing in tandem cold rolling on strip thickness and to improve the AGC accuracy,oil film thickness experiment was done.
为了分析冷连轧机支撑辊动压油膜轴承的油膜厚度变化对带钢厚度的影响,提高轧机AGC精度,进行了油膜厚度测试实验。
3.
The hydrostatic slide’s principle,characteristic,classification,applicable situation were introduced,and the effect factors for slide design ,including load capacity,oil film rigidity,oil film thickness as well as slide clearance were analyzed.
介绍了液体静压导轨工作原理、特点、分类及适用场合 ,分析了承载能力、油膜刚度、油膜厚度以及导轨间隙等静压导轨设计的影响因素。
5) film thickness
油膜厚度
1.
The inlet film thickness was defined by analyzing the inlet zone,and the influence of unsteady variables such as strip tension stress,rolling speed and inlet angle on inlet film thickness was considered.
通过入口区的分析,确定了入口油膜厚度。
2.
This paper clarifies the relations between the performance parameters and structural parameters These performance parameters include maximum film stiffness maximum load capacity and minimum power consumption On the basis of these analysis, the equations of minimum film thickness and structural parameters of restrictor are obtained.
本文阐明了平行圆盘形静压支承的最大油膜刚度，最大承载能力和最小功率损耗等性能参数与圆盘支承结构参数之间的关系，并得到了最小油膜厚度与阻尼管结构参数的关系式，为该类支承的结构设计提供了简捷的方法。
6) oil thickness
油膜厚度
1.
Via detecting the features of oil fluorescence spectrums, high spatial resolution and high-precision information of oil spills area can be obtained rapidly in real-time, including the type of oil spills, the oil thickness and so on.
通过对海上溢油的荧光光谱特征的探测,可以快速、实时、准确的获得高空间分辨率、高精度的海上溢油区的溢油种类、油膜厚度等信息。
补充资料：气态膜
分子式：
CAS号：
性质：当不溶物单分子膜成膜物质的分子占据面积很大（如大于40nm2/分子）时，表面压很小（常小于0.1mN/m）。这种膜的状态可用二维理想气或二维范德华气态方程描述。这种膜称为气态膜。
CAS号：
性质：当不溶物单分子膜成膜物质的分子占据面积很大（如大于40nm2/分子）时，表面压很小（常小于0.1mN/m）。这种膜的状态可用二维理想气或二维范德华气态方程描述。这种膜称为气态膜。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条