1) close top roll housing
闭口式机架
2) closed topped housing
闭口式机架
3) closed pores
闭口气孔
4) lock pin
闭口销
1.
The reason was searched why the lock pins of tin bronze would break by means of macroscopic examination, chemical analysis, metallographic test, electron microscopic observation and EDS.
采用宏观检查、化学分析、金相检验、电镜观察、断口能谱法分析了锡青铜闭口销的断裂原因,结果表明,闭口销的断裂是由于材料成分差错,导致其在应力腐蚀作用下早期断裂。
5) Closed Groove
闭口孔型
6) closed thin wall
闭口薄壁
7) Stochastic FEM
闭口箱梁
8) close-slot
闭口槽
1.
Using neural network to estimate the skin effect cofficient of squirrel-cage close-slot high-speed asychronous motor;
利用神经网络预测高速变频电机转子闭口槽集肤效应系数
9) shutting angle
闭口角
1.
The study of shedding motion of the heald frame abodt opening angle different from shutting angle;
开闭口角不等的综框组合运动规律的探讨
2.
The paper discusses the shedding motion of the frame about opening angle different from shutting angle, applying common shedding regular patterns, studies three combining curve equations suited to technological requirements of shed by means of choosing different opening angle, and gives the feature analysis and comparison each other.
本文利用综框常用的运动规律， 推导出适宜开口工艺要求的三种开口角与闭口角不等的组合曲线方程， 探讨了开口角不等的踏盘开口综框运动规律， 并对各运动规律作了特性分析和比
10) seal formation
闭口化成
补充资料：闭口孔型
闭口孔型
closed pass
b ikou kongxing闭口孔型(elosed pass)札棍的棍缝:位于 帐…二J 闭口孔型孔型周边之外且有孔型顿口的孔型，如图所示。通常，在开廿孔型和闭口孔型中札制轧件，都可以获得同一种规格的产品，但闭口孔型对轧件侧边的加工比开口孔型好，因而产品的精度和力学性能都比较好。由于闭口孔型在轧辊上的切槽很深，降低了轧辊的强度，切槽车削加工也比较困难，轧件对孔型侧壁的磨损也较大。所以，一般在轧制异形断面型材时才采用闭口孔型。 (朱殿强)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条