1) airless spray unit
真空喷涂装置
2) Vacuum injection device
真空喷射装置
3) vacuum spraying
真空喷涂
1.
The advantages of vacuum spraying are that the said active feed additives not only can be avoided from thermal processing but also can permeate into pellets, therefore their activity can be reserved to a maximum, bring their functions into full play.
真空喷涂技术的优点是可以让上述活性饲料添加剂避免热加工过程,并渗透到颗粒内部,最大限度地保留活性,发挥功能。
4) vacuum spray
真空后喷涂
1.
In order to reduce microecological preparation loss during the manufacture of compound feeds,a series of experiments taking Bacillus subtilis as an example were carried out based on vacuum spray technology.
以枯草芽孢杆菌为研究对象,考察了真空后喷涂系统对颗粒间均匀性及颗粒内外均匀性的影响因素。
5) vacuum device
真空装置
1.
In this article, based on the problems in the use of the film dropping evaporation equipment and with RNJM03-4200 third Film Dropping Evaporation Equipment as the example, one method of appropriate disposition of the vacuum device was introduced.
以ＲＮＪＭ０３－ ４２００ 型三效降膜式蒸发设备为例，针对近些年来降膜式蒸发设备真空装置出现的问题，就如何合理配置真空装置予以描述。
2.
The vacuum device for three-effect and four-compartment evaporation process of diaphragm caustic soda was transformed,which reserved the water jet condensers and added a combined vacuum device of a surface condenser and a vucuum pump.
对隔膜法烧碱三效四体蒸发工艺的真空装置进行改造,保留水喷射冷凝器,增加表面冷凝器加真空泵的真空装置,提高了真空度,降低了蒸汽消耗。
6) Vacuum
[英]['vækjuəm] [美]['vækjuəm]
真空装置
1.
Design of Control System for Vacuum Pressure Casting Mould Based on LOGO!;
基于LOGO!的压铸模具真空装置控制系统设计
2.
Aimed at the pore deficiency of conventional pressure casting,a vacuum of mould based on LOGO! controlled is designed.
针对传统压力铸造的气孔缺陷,设计了一套基于LOGO!控制的模具真空装置,并从总体方案、气路部分、控制部分三方面较详细的介绍了设计方法。
补充资料：喷射真空泵
分子式：
CAS号：
性质：用于抽真空的一种蒸汽喷射泵。单级仅能达到有限的真空度。为获得更高的真空度，可采用多级。
CAS号：
性质：用于抽真空的一种蒸汽喷射泵。单级仅能达到有限的真空度。为获得更高的真空度，可采用多级。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条