1) mesotherm plant
中温植物
2) mesotherm
中温植物
3) moderate temperature
中温
1.
Study on mechanical properties of moderate temperature curable and solvent-free epoxy resin binder;
无溶剂中温固化环氧胶粘剂力学性能研究
2.
A moderate temperature Zn-Ca phosphating technology was developed and successfully used for automobile wheel rims.
针对汽车钢圈,采用对比试验的方法,研究出锌钙系中温磷化液的配制方法和使用工艺。
4) elevated temperature
中温
1.
By a series of pulsating cyclic tests of 16MnR steel under stress control at elevated temperature,transformation laws of the damage variable were measured at different maximum stresses at.
通过16MnR钢在中温应力控制条件下的脉动循环试验,测出在相同温度、不同最大应力以及相同最大应力、不同温度下的损伤变量变化规律。
2.
By low cycle fatigue experimentation of 16MnR under stress control at elevated temperature, stress-life curve of 16MnR at 300℃ was obtained.
Langer公式不能应用于 16MnR材料中温疲劳设计当中 ,对B 。
3.
Low cycle fatigue characteristic of 16MnR under stress control at elevated Temperature is investigated, relations between young's modulus, total strain amplitude, cyclic hysteresis energy and cycles, magnitude of stress is discussed to understand behavior of stress-strain at elevated temperature.
研究 16MnR材料 30 0℃环境下的低周疲劳特性 ,讨论材料中温环境下弹性模量、总应变幅、塑性应变能与循环次数和应力水平的关系 ,深入认识 16MnR材料中温环境下低周疲劳的应力应变行为。
5) middle temperature
中温
1.
Study on complexants of acidic electroless nickel plating at middle temperature;
中温酸性化学镀镍络合剂的研究
2.
A numerical value study on chemical reaction of CaCO_3 particles during the middle temperature reaction;
中温反应过程中石灰石颗粒化学反应的数值研究
6) intermediate temperature
中温
1.
The development of the larger axial force intermediate temperature balance in the hypersonic wind tunnel;
高超声速风洞大轴向力中温天平的研制
2.
The electrochemical performance of H2S-Air solid oxide fuel cells (SOFCs) was characterized at different intermediate temperatures and H2S flow rates,r(H2S).
在中温(650～850℃),分别测定了H2S-AirSOFC的电输出性能随H2S流速r(H2S)、运行温度的变化情况。
7) medium temperature
中温
1.
Study of electroless nickel plating process and its additive at medium temperature;
中温化学镀镍工艺及添加剂的研究
2.
Properties of Ag-Au-Ge medium temperature solder;
Ag-Au-Ge中温钎料的性能
8) intermediate temperate
中温
9) intermediate temperature solder
中温钎料
1.
Research progress of intermediate temperature solder for electronic device;
电子器件用中温钎料的研究进展
10) warm quick fever
中温快烧
补充资料：中温烘干
分子式：
CAS号：
性质：加热干燥按温度分类，中温烘干的温度为100～150℃，它适用于热固性涂膜和涂于金属表面涂膜的干燥。金属制品用烘漆的烘干温度以热固性氨基醇酸树脂涂料和丙烯酸树脂涂料为例，一般为100～180℃。
CAS号：
性质：加热干燥按温度分类，中温烘干的温度为100～150℃，它适用于热固性涂膜和涂于金属表面涂膜的干燥。金属制品用烘漆的烘干温度以热固性氨基醇酸树脂涂料和丙烯酸树脂涂料为例，一般为100～180℃。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条