1) condensing rate
冷凝速率
2) rapid solidification
快速冷凝
1.
This paper has analyzed the reasons of the brittleness of rapid solidification Al-Li alloys and introduced some main toughening methods in manufacturing,forming and heat treatment of the alloys.
通过对快速冷凝 (RS)Al-Li合金低塑韧性原因的分析 ,介绍了Al-Li合金制备、成材、热处理等过程中一些主要韧化途径 ,并简单讨论了获得较好综合性能的Al-Li合金制品的工艺方法及大致工艺参数范
2.
The microstructure and effect of grain refining of Al-Ti-B interalloy rods prepared by the process of rapid solidification-extrasion have been investigated by means of X-ray diffrac-tion，SEM and optical microscope in this paper.
借助Ｘ射线衍射、扫描电镜、金相显微技术等手段，对采用快速冷凝喷粉或离心制粒－挤压法制得的Ａｌ－Ｔｉ－Ｂ中间合金线杆的组织结构和其晶粒细化效果进行了研究。
3.
By means of rapid solidification,Al-Cu-Fe-Zn alloy powders were produced.
本文通过快速冷凝方法制得了Al-Cu-Fe-Zn系合金粉末。
3) condensing rate
冷凝速度
4) condensing efficiency
冷凝效率
5) solidification rate
凝固速率
1.
The empirical results indicate that the increase of solidification rate can achieve intermetallic particles reinforced phase with ideal morphological features in Al-Ni alloy.
实验结果表明,提高凝固速率可以使Al-Ni合金获得理想形貌的金属间化合物强化相。
2.
Exporimental results show that the stress- rupture life of DZ22 at 980℃ and 220 MPa was increased from 71 hours and 50 nunutes to 168 hours and 5 minutes at relatively high solidification rate.
本文采用ＺＭＬＭＣ超高梯度定向凝固法（ＺＭＬＭＣ法），研究了两种凝固速率下ＤＺ２２合金的高温力学性能和组织。
3.
The dendritic arm spacings and microsegregations of directionally solidified superalloy DZ22 at various solidification rates have been studied with the help of a ZMLMC directional solidification equipment.
采用新研制的超高梯度定向凝固装置，研究了不同凝固速率下定向凝固高温合金ＤＺ２２的枝晶臂间距和枝晶偏析。
6) agglomerating velocity
凝集速率
补充资料：表面冷凝器
分子式：
CAS号：
性质：一般间壁式冷凝器。例如列管式冷凝器，冷却水在管内流动，蒸汽在管子外表面冷凝。
CAS号：
性质：一般间壁式冷凝器。例如列管式冷凝器，冷却水在管内流动，蒸汽在管子外表面冷凝。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条