1) drawing rate
拉制率
2) drawing
[英]['drɔ:ɪŋ] [美]['drɔ·ɪŋ]
拉制
1.
In this paper, oxidization treatment of tantalum wire before drawing is studied.
研究了钽丝拉制前的氧化处理，并对比了加热氧化、阳极氧化和不氧化３种情况下钽丝的拉制性能及其氧含量随钽丝深度的变化。
2.
In order to meet the performance demands of train lorry,a die forging-drawing method based on structure features analysis was proposed to form the L-A break beam frame.
为满足铁路货车运输对新型制动梁架产品性能的要求,在分析了制动梁架产品结构特点的基础上,提出了采用"模锻-拉制"工艺成形制动梁架的新方法。
3) wire drawing
拉制
1.
A new type of copper powder separator is presented, which serves to separate the copper powders produced during the wire drawing process from the drawing lubricant.
介绍一种新型的铜粉分离装置 ,可利用液体旋转产生离心力的原理 ,将拉制铜线时产生的铜粉从润滑液中分离出来。
4) withdrawal rate
抽拉速率
1.
Effects of withdrawal rate on microstructure and mechanical property of single crystal superalloy SRR99;
抽拉速率对SRR99单晶高温合金组织和性能的影响
2.
Relationship between primary dendrite arm spacing of Al-4.5%Cu alloy and withdrawal rate during unidirectional solidification;
定向凝固Al-4.5%Cu合金枝晶组织与抽拉速率的关系
5) efficiency of drawing
拉深效率
1.
A new method that changes the flow tendency of metal by exerting forces initiatively to improve the efficiency of drawing is introduced.
实践证明,该模具对提高筒形件的拉深效率和质量是切实有效的。
6) tensile rate
拉伸速率
1.
Effect of tensile rate on mechanical properties of NEPE propellant;
拉伸速率对NEPE推进剂力学性能的影响
2.
The effect of tensile rate on the lower yield strength of the iron and steel material was investigated,the advantage of the tensile rate of GB/T228-2002 was discussed.
研究了拉伸速率对钢铁材料下屈服强度的影响,讨论了GB/T2 2 8-2 0 0 2中拉伸速率规定的科学性。
3.
The effects of particle volume fraction, tensile rate and interface bonding strength on the properties of GB/HDPE composites were studied by tensile test and SEM observation.
通过ＧＢ／ＨＤＰＥ的拉伸实验和断口形貌分析， 研究了颗粒体积分数、拉伸速率、界面强度对ＧＢ／ＨＤＰＥ复合材料力学性能的影响。
补充资料：单一费率制
单一费率制
【单一费率制】见“固定费率制”。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条