1) class A steel
甲类钢
2) HSS-like
类高速钢
1.
Experimental Research on Laser Overlaying of HSS-like Metal on Hot Die Steel H13;
热作模具H13钢表面激光堆焊类高速钢的实验研究
3) Arch type
钢架类型
4) Type of Steel
钢的种类
5) armored steel
装甲钢
1.
Finite element analysis of anti-break performance and anti-shock strength of the armored steel thermit welding joint;
装甲钢板铝热焊接头抗断性和抗击强度有限元分析
2.
HAZ/WM interfacial microstructure is observed either in as-welded or as-quenched(PWHT:900 ℃×5 min or 1 100 ℃×1 min,Water-quenched)TWE312/616 high-strength armored steel weldments by means of SEM or TEM respectively.
采用SEM、TEM观察焊态和焊后热处理(900℃×5min或1100℃×1min,水淬)TWE312/616装甲钢HAZ/WM界面区及其附近的组织结构,采用NanoTest600对界面区附近的硬度分布进行测试。
6) armor steel
装甲钢
1.
The microstructure has been analyzed to the armor steel with attacks,it was discovered that the destruction of armored steel under the impact load is first produces the crack source in the crystal boundary intersection point,then connects mutually.
通过对冲击破坏装甲钢组织分析,发现纯净装甲钢在冲击载荷下破坏过程中是在晶界交汇处(三叉点)产生裂纹源,然后相互连接的结果。
2.
Four points bending low-cycle fatigue lifetime of armor steel 616 Tee joints after weld finishing has been analyzed and measures to improve the fatigue lifetime have been proposed in the paper.
本文对转炉 6 16装甲钢T型焊接接头四点弯曲低周疲劳试验结果进行了分析、研究 ,阐述了提高T型焊接接头低周疲劳寿命的有效措施。
3.
The dynamic compression properties of armor steel 603 and 675 have been systematically tested using a one-dimension Hopkinson compression bar apparatus.
利用一维Hopkinson压杆实验设备,对603、675两种装甲钢的动态压缩力学性能进行了较为系统的测试,在此基础上建立了2种装甲钢的Bodner-Partom本构方程,经程序计算与实际试验结果对比,表明本构方程能够较好地反映材料在动载荷条件下的力学行为。
补充资料：甲类钢
分子式：
分子量：
CAS号：
性质：见普通钢。
分子量：
CAS号：
性质：见普通钢。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条