1) eccentric construction sector
偏心施工段
3) construction error
施工偏差
1.
Stochastic carbonation durability analysis of pre-stressed concrete structure regarding construction error of concrete cover;
基于保护层施工偏差的预应力混凝土结构碳化耐久性研究
2.
The influence of construction error such as vertical deviation of column etc,are frequently met in construction.
超高层钢结构安装过程中的柱身垂偏等施工偏差对结构性能的影响程度是工程中经常遇到的问题。
4) construction progress partial pressure
施工偏压
1.
Based on the finite element analysis of double-arched tunnel under terrain partial pressure and construction progress partial pressure separately,the deformation and mechanics of middle wall of double-arched tunnel are mainly analyzed in this paper.
基于连拱隧道分别在地形偏压与施工偏压条件下完成了数值模拟,并对中墙内力及变形情况进行了分析。
5) construction stage
施工阶段
1.
How to do well the supervision work in the engineering construction stage;
浅析如何做好工程施工阶段的监理工作
2.
Engineering cost control in the construction stage of the construction project;
建设项目施工阶段工程造价控制
3.
Discussion on the project cost control in construction stage;
浅谈施工阶段项目的成本控制
6) construction phase
施工阶段
1.
Reorganizing method of engineering supervision data in construction phase;
谈施工阶段工程监理资料的整编方法
2.
Analysis on effective cost control measures in design and construction phases;
浅析设计和施工阶段造价的有效控制
3.
Study on announcement system at construction phase;
浅议工程施工阶段的公示制度
补充资料：在AutoCAD中偏心圆锥与偏心圆台实体的画法
现在要画一个偏心圆锥,底面在WCS的XY平面上,圆心(0,0,0),半径100,顶点(300,0,400)在ZX平面上.
1)连接PA,PB. A(-100,0,0) B(100,0,0)
图1
在当前坐标下:
2)延长PA到C,使PA=CA;延长PB到D,使PB=DB;
3)连接CD;
4)以CD为直径画圆;
5)用XLINE命令中的二等分选项作角CPD的角平分线PO,交CD于O;
6)过O作CD的垂线,交圆于E,F;
图2
7)用三点UCS命令,取三点为:O,P,C;
8)过点O作PO的垂线GO,交PC于G;
图3
9)再次用三点UCS命令,取三点为O,F,G;
10)现在就可以画椭圆锥了!
cone-e-c-捕捉O点-捕捉F点-捕捉G点-a-捕捉P点;
图4
11)回到WCS,剖切椭圆锥
SL-选择椭圆锥-回车-XY-回车-捕捉P点.
12)删除辅助线条.
图5
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条