1) ultrafine grained steel plate
超级钢中板
2) super steel sheet
超级钢板
1.
Numerical simulation and testing research of U-bending springback for super steel sheet
超级钢板U型弯曲回弹的数值模拟和实验研究
3) super steel
超级钢
1.
Test research of stamping property for super steel plate;
超级钢板材冲压性能的试验研究
2.
Effect of cooling rates and deformation on microstructure and mechanical properties of 700MPa super steel;
冷速和变形对700MPa超级钢组织和性能的影响
3.
Tensile test research of stamping property for super steel plate;
超级钢板料冲压性能的拉伸试验研究
4) ultrafine grain steel
超级钢
1.
Prediction of grain size in the HAZ of the ultrafine grain steel joint;
400MPa级超级钢焊接热影响区晶粒尺寸的预测
2.
The specimens of ultrafine grain steel of 400MPa were heated at different temperature for 5 minutes,and then cooled by air and water respectively,and their microstructure and properties were observed and tested.
对 4 0 0MPa级超级钢试样在不同温度下加热保温 5min ,并分别进行空冷和水冷 ,然后进行组织分析和性能检测。
5) super-steel
超级钢
1.
The survey on the research and development of new material of super-steel;
新一代超级钢铁材料的研发
2.
New Generation of Steel Materials——Super-steel;
新一代钢铁材料——超级钢
3.
On the high-frequency fatigue tester PLG-100,the crack propagation rate of 400 MPa super-steel strip was tested at 80 Hz by three-point bending method.
采用PLG-100高频疲劳试验机,在试验频率为80 Hz条件下,应用三点弯曲法对400 MPa超级钢板进行了裂纹扩展速率实验;绘制出ANS400裂纹扩展速率da/dN与应力强度因子幅ΔK之间的关系曲线;利用Origin7。
6) ultra fine grain steel
超级钢
1.
Influence of technology parameter for the ultra fine grain steel welding temperature fields;
工艺参数对超级钢焊接温度场的影响
2.
Crystalline grain size simulation for HAZ of ultra fine grain steel under different welding electric current and voltage;
不同焊接电流电压下超级钢热影响区晶粒尺寸的数值模拟
3.
The welding temperature field of the ultra fine grain steel was obtained by numerical simulation.
采用数值模拟方法得到超级钢焊接温度场,在热影响区温度场基础上,结合晶粒长大动力学原理计算热影响区晶粒尺寸,并实验加以验证,绘制不同参数下超级钢热影响区晶粒尺寸图,以作为优化其焊接工艺的依据。
补充资料：邯钢集团舞阳钢铁公司九辊热矫直机矫直厚板
邯钢集团舞阳钢铁公司九辊热矫直机矫直厚板
邯钢集团舞阳钢铁公司九辊热矫直机矫直厚板
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条