1) multiple stress singularity
多重应力奇异性
1.
A numerical method for determination of multiple stress singularity orders and corresponding stress intensity coefficients is presented in this paper, by the example of plane problems with two stress singularity orders, based on the numerical solutions obtained by common numerical procedures such as FEM and BEM.
以具有两个应力奇异性次数的平面问题为例 ,提出了一种利用普通的数值分析结果确定奇异点附近多重应力奇异性的各阶次数以及相应的应力强度系数的数值分析方法。
2) double stress singularities
双重应力奇异性
1.
The stress field near the tip of V notch in a plate with double stress singularities is described,and two methods of determining the double stress intensity factors, K 1 and K 2, which corresponds to double stress singularities are presented on the basis of the isochromatics obtained from the photoelastic experiment.
文章在分析具有双重应力奇异性平面 V形切口尖端应力场的基础上 ,提出了基于由光弹性实验获得的等差线确定与双重应力奇异性对应的双应力强度因子 K1 、K2 的光弹性实验方法 ,并通过对模型的光弹性实验 ,运用该方法较好地确定了均质材料 60°单应力奇异性 V型对称切口模型和均质材料 45°双重应力奇异性 V型非对称切口模型的应力强度因子 ,验证了该文中提出的方法的正确
3) stress singularity
应力奇异性
1.
Numerical simulation on stress singularity at the end of soft cushion;
软垫层末端应力奇异性数值模拟
2.
Problem of elastoplastic stress singularity near V-notch tip;
V型切口尖端的弹塑性应力奇异性问题
3.
The distributions of the stress along interface after the disappearance of stress singularity are analyzed and discussed.
应用有限单元法对上述结果进行了验证,并对消除应力奇异性后的界面应力进行了分析与讨论;结果表明:采用刚好使奇异性消失的接合角会获得最均匀的界面应力分布。
4) moire interferometry and hybrid method
端部应力奇异性
5) three-dimensional stress singularity
三维应力奇异性
6) oscillatory stress singularity
振荡应力奇异性
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条