1) coaxial single lap bonded joint
同轴单搭接胶接接头
1.
Investigation on stress distribution in coaxial single lap bonded joint;
同轴单搭接胶接接头应力分布的探讨
2) single-lap joint
单搭接胶接接头
1.
Influences of adherent thickness,temperature and velocity on strength of adhesively-bonded single-lap joints
板厚、温度和速度对单搭接胶接接头强度的影响
4) single lap joint
单搭接接头
1.
Effect of preformed angle on the shear strength of adhesively bonded single lap joints;
预偏角对单搭接接头强度的影响
2.
Numerical analysis on stress distribution in single lap joint with a metal inlay
含镶嵌块单搭接接头应力分布的数值分析
3.
The effect of elastic modulus of adhesive on the str es s distribution in aluminium alloy single lap joint was investigated using elasti c-plastic finite element method(FEM).
运用弹塑性有限元法,研究了胶粘剂弹性模量对含间隙的铝合金单搭接接头上应力分布的影响。
5) single-lap joint
单搭接接头
1.
s: The effect of curing condition of HT1012 conductive adhesive on the shear strength of single-lap joint was investigated.
研究了固化工艺参数对由HT10 12型铜粉导电胶制备的单搭接接头剪切强度的影响。
6) single-lap joints
单搭接接头
1.
Influence of length and position of recessing on bonding strength of single-lap joints;
间隙长度与间隙位置对单搭接接头强度的影响
2.
s:The effect of the recessing length on the strength and stress distribution of adhesively bonded single-lap joints was discussed.
研究了在单搭接接头上、胶缝中预留的不同长度间隙对接头剪切强度和剪切应力分布的影响。
3.
Based on analyzing finite element model for concentrated recessing in adhesively bonded single-lap joints, a new method of instead of plane strain condition with plane stress model is used in this paper to investigate the shear stress distribution in continuous or intermittent recessing adhesive layer.
在分析现有的单搭接接头胶层中有集中间隙的有限元模型的基础上,提出了用平面应力随厚度变化的模型取代平面应变模型思路,对比了连续胶层与胶层中有3个断续间隙时搭接部位上剪切应力分布情况。
补充资料：黏合搭接接头
分子式：
CAS号：
性质：两个被粘物部分叠合粘接在一起形成的接头。搭接比对接形式抗剪强度高，而且可靠，是一种十分普遍使用的粘接形式。
CAS号：
性质：两个被粘物部分叠合粘接在一起形成的接头。搭接比对接形式抗剪强度高，而且可靠，是一种十分普遍使用的粘接形式。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条