1) silicone modified phenolic epoxy resin
有机硅改性酚醛环氧树脂
1.
A silicone modified phenolic epoxy resin(SMPER) as sand control agent(SCA) is developed to solve severe sanding problems in oil wells in fine siltstone reservoirs of Shengli.
针对胜利油田出砂严重的细粉砂岩油藏的油井,研制了有机硅改性酚醛环氧树脂稳砂剂。
2) organosilicon-modified phenol-formaldehyde resin
有机硅改性酚醛树脂
1.
The organosilicon-modified phenol-formaldehyde resin (PFR) was prepared by graft copolymerization of octamethylcyclotetrasiloxane(D_4) and phenol-formaldehyde resin under suitable conditions.
用八甲基四硅氧烷(D4)对酚醛树脂进行接枝共聚反应,得到有机硅改性酚醛树脂,并对其性能指标和留着效果的影响因素进行了初步的研究;将有机硅改性酚醛树脂与聚氧化乙烯(PEO)组成双元助留体系,应用于废纸脱墨浆抄纸工艺,研究其助留助滤性能和对纸张表面性能的影响。
2.
Study on the synthesis and retention effect of organosilicon-modified phenol-formaldehyde resin;
该文利用酚醛树脂与有机硅化合物的接枝共聚反应制备了有机硅改性酚醛树脂,并将其与聚氧化乙烯(PEO)组成双元助留体系,应用于废纸脱墨浆的助留实验。
3) silicone modified epoxy resin
有机硅改性环氧树脂
1.
In order to study the effect of laser parameters on the mass ablative rate of the carbon fiber reinforced silicone modified epoxy resin composite,laser irradiation experiments of the composite were carried out by a high power CO_2 laser with different laser parameters.
为了研究激光参数对碳纤维增强有机硅改性环氧树脂复合材料质量烧蚀率的影响规律,选用不同激光参数、采用高强度CO2激光器对该复合材料进行了激光辐照试验。
2.
The synthetic methods, properties, applications of silicon resin, linear polysiloxane, silicone modified epoxy resin were reviewed for the next phase of work, and a solid theoretical foundation.
本论文的研究主要分为四部分:第一部分对硅树脂、线型聚硅氧烷、有机硅改性环氧树脂的合成方法、性能研究、应用进行了综述,为开展研究奠定了理论基础。
3.
The results indicate that silicone modified epoxy resin has excellent performances because of their combined advantages and novel properties, and the compact coating was obtained with good adhesion,hardness and toughness.
采用数种有机硅氧烷合成了有机硅树脂,用有机硅树脂对环氧树脂进行化学改性,制得了有机硅改性环氧树脂。
4) epoxy modified silicone resin
环氧改性有机硅树脂
5) Epoxy-polyslioxane-phenolic three-component resin
环氧有机硅酚醛三元树脂
6) rosin modified phenol-aldehyde epoxy resin
松香改性酚醛环氧树脂
1.
The curing process of rosin modified phenol-aldehyde epoxy resin (RPAE for short), which was self-made, with 4,4\'-diaminodiphenylsulfone, phthalic anhydride and polyamide as curing agents were traced by using FT-IR.
以自制的松香改性酚醛环氧树脂(RPAE)为对象,采用FT-IR跟踪了RPAE与三种固化剂4,4-二氨基二苯砜、邻苯二甲酸酐和聚酰胺的固化过程,得到了较佳的固化工艺,并在最佳工艺条件下对RPAE与三种固化剂组成的固化体系进行固化,并用FT-IR、TG等表征手段考察了固化物的结构和性能。
2.
Kinetics of curing reaction of rosin modified phenol-aldehyde epoxy resins(RPAE) with 4,4\'-diamino diphenyl sulphone(DDS) was investigated by DSC.
以自制的松香改性酚醛环氧树脂(RPAE)为对象,采用差示扫描量热法研究了其与4,4-二氨基二苯砜组成的体系(RPAE/DDS)的固化动力学,利用Kissinger方程计算得到体系的固化热约为109。
补充资料：有机硅改性树脂
分子式：
CAS号：
性质：指用有机硅中间体和其他常用的有机树脂制成的改性树脂。这种改性树脂具有两种树脂的优点，弥补了有机硅树脂的不足，诸如固化温度高(150～200℃)、固化时间长、不便于大面积施工、对底层附着力差、耐有机溶剂性差、高温时漆膜机械强度不好、价格较贵等缺点。通常采用冷拼法和化学法制成。一般有机硅改性的有机树脂有：醇酸树脂、聚酯树脂、环氧树脂、丙烯酸树脂、聚氨酯树脂、酚醛树脂等。
CAS号：
性质：指用有机硅中间体和其他常用的有机树脂制成的改性树脂。这种改性树脂具有两种树脂的优点，弥补了有机硅树脂的不足，诸如固化温度高(150～200℃)、固化时间长、不便于大面积施工、对底层附着力差、耐有机溶剂性差、高温时漆膜机械强度不好、价格较贵等缺点。通常采用冷拼法和化学法制成。一般有机硅改性的有机树脂有：醇酸树脂、聚酯树脂、环氧树脂、丙烯酸树脂、聚氨酯树脂、酚醛树脂等。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条