2) forming curve
成形曲线
1.
The equation of forming curve of belt and formula of length in transition section of tubular belt conveyor are derived,which can be used to arrange the rollers rationall
本文推导出了圆管胶带输送机过渡段胶带成形曲线方程和过渡段长度计算公式,可用作合理布置过渡段托辊的依据。
3) forming curves
形成曲线
1.
The influences of phosphorus-containing compounds on the forming curves of electrolytes.;
含磷化合物对电解液形成曲线的影响
4) forming limit curve(FLC)
成形极限曲线(FLC)
5) two-dimentional forming curve
二维成形曲线
6) forming limit curve
成形极限曲线
1.
It is assumed that the material damage in the localized zone results in the necking in the metal sheet, then the development of in-plane strain localization in sheets was analyzed and the forming limit curves (FL Cs) were predicted for Al 2023-T3 and Al 6111-T4 sheets.
最后用有限元法计算得到了2024-T3和6111-T4铝板的成形极限曲线以及相应的试验数据。
2.
The influence factors,such as grid size,evaluating phase and evaluating position,in determination of forming limit curves(FLCs) were researched by dynamic strain determination method.
采用动态应变测量方法对成形极限曲线(FLC)检测中网格的大小,测量的时机(破裂前或破裂后测量),测量的位置等因素进行了试验研究。
补充资料：Hesse曲线(代数曲线的)
Hesse曲线(代数曲线的)
Hessian (algebraic curve)
11油限曲线(代数曲线的)【H台自11(.妙如允.抖e);recc咖，T~aaa，即r药pa一吸ee二o‘二p.助蓝] n次代数曲线(司罗玩水c~)的He丈祀曲线就是其极二次曲线能分裂为两条直线的点的集合，也是第一极曲线的二重点构成的集合.n次非奇异曲线的He丈七曲线是一条次数为3伪一2)、类为3(n一2)(3n一7)的曲线.设介O是这条n次曲线的齐次坐标方程，关丘=刁:f/刁xi刁、，则它的He丈犯曲线的定义方程为 !不:关:五，} }五:关:五31=0. }人，人2人3}特征不等于3时的三次非奇异曲线的H既七曲线与这条曲线交于9个通常拐点.因O.H改e(l 844)而得名. A .E.H困阳。B撰
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条