说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 金属螯和亲和层析
1)  Metal-chelate affinity chromatography
金属螯和亲和层析
2)  Immobilized metal ion affinity chromatography
金属螯合亲和层析
1.
Purification of recombinant hepcidin fusion protein by immobilized metal ion affinity chromatography;
重组Hepcidin融合蛋白的金属螯合亲和层析纯化
2.
Purification of anti-HBcAg monoclonal antibodies using immobilized metal ion affinity chromatography
金属螯合亲和层析法纯化抗乙肝核心抗原单克隆抗体
3.
Immobilized metal ion affinity chromatography(IMAC) is one of the most efficient techniques in biological macromolecular separation and purification which has the advantages of high specificity, high recovery efficiency, high purity and single-step operation.
金属螯合亲和层析具有螯合介质制备简单,吸附容量大,选择性及通用性较好,易于再生,成本低等优点,是分离纯化蛋白质等生物工程产品最有效的技术之一。
3)  metal chelate affinity chromatography
金属螯合亲和层析
1.
Superoxide dismutase(SOD) was preliminarily separated from maize by precipitation with ammonium sulfate and gelfiltration and then purified by metal chelate affinity chromatography(MCAC).
利用硫酸铵分级沉淀、凝胶过滤初步分离了玉米SOD,利用金属螯合亲和层析纯化了SOD。
2.
Isolation and purification of two SOD components(A and B) from maize by metal chelate affinity chromatography and DEAE-cellulose ion-exchange chromatography and determination of their qualities had been carried out in this experiment.
利用金属螯合亲和层析和DEAE-纤维素离子交换层析相结合的方法分离纯化玉米SOD,得到2种达到电泳纯的SOD组分(A、B),并对它们的基本性质进行了初步分析。
4)  Immobilized metal ion affinity chromatograph(IMAC)
金属螯合亲和层析
1.
By means of Immobilized metal ion affinity chromatograph(IMAC),comparing the results of different elution methods,a optimum purification route was attained.
采用金属螯合亲和层析法对十聚体脑钠素进行了纯化 ,比较了咪唑洗脱法和降pH值洗脱法对目标蛋白的纯化效果 ,得到了一条纯化目标蛋白最佳亲和层析纯化路线 ,为后续实验打下了很好的基
5)  metal-chelated affinity chromatography
螯合金属亲和层析
6)  immobilized me tal-chelating affinity chromatography
固定化金属螯合亲和层析(IMAC)
补充资料:金属化纸和金属化薄膜
      表面上蒸镀一层很薄 (0.1微米左右)的金属层的纸或薄膜。金属化纸曾应用于电缆、变压器作为屏蔽层,现多用于制造电容器。金属化纸和金属化薄膜的特点是具有自愈性,即当某处击穿时,短路电流使击穿部位周围的金属膜熔化并蒸发而又恢复绝缘性能,因此显著减少纸或薄膜中贯穿性导电疵点和弱点对击穿强度的影响,从而提高工作场强。低压纸介电容器如用铝箔极板(6~7微米),必须用2~3层纸或薄膜,若用金属化纸或金属化薄膜,只要1层即可,极板的厚度也由6~7微米减少到0.1微米左右,大大节省材料。直流或脉冲电容器用金属化纸时,为了提高绝缘电阻,可以在纸的单面或双面涂以约1微米厚的快干纤维漆,然后在真空中蒸镀0.1微米的金属膜。交流电容器用的金属化纸或金属化薄膜,为了不使介质损耗增大,不喷漆,而是在纸或薄膜表面上直接蒸镀金属膜。用于蒸镀金属膜的金属有锌、镉、镍和铝等,以锌最适合(沸点较低)。有些薄膜(例如聚酯薄膜)可以先在表面上蒸镀银层,然后再蒸镀锌层。
  
  金属化纸或金属化薄膜吸潮后,特别是在较高温度下容易被损伤腐蚀,在储存、加工过程中要采取适当的防潮措施。金属化纸一般不可用氯化物浸渍,以防止纸中析出的氢同氯化物浸渍剂析出的氯作用形成腐蚀性的氯化氢;但加了某些特殊的稳定剂后也可以用氯化物浸渍。
  

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条