说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 算子子空间
1)  operator subspace
算子子空间
1.
The definitions are given of operator subspace,operator product space and operator quotient space ,together with their characterizations.
在算子开集理论中给出了算子子空间、算子积空间和算子商空间的定义,得到了这三种空间的若干性质。
2)  spatial operator
空间算子
1.
The spatial operators based on label are realized to finish altering polygon while collecting field data,and the .
对GPS数据质量采用神经元辨识的方法进行控制;对大数据量底图数据采用一种新的地图综合方法建立多级显示机制,节省内存,提高图形显示效率;建立基于la-bel的空间算子实现方式,完成采集图斑的现场变更,减少内业数据处理的工作量。
3)  operator space
算子空间
1.
In this paper a sufficient condition for σ- weak closed operator spaces on Banach spaces with hereditary n- reflexiyity was obtained,which is the improvement to some results of [1],[2]and [3].
对文献 [1]、 [2 ]及 [3]中的相应结果作了改进 ,得到Banach空间上的σ -弱闭的算子空间具有遗传n -自反性的一个充分条
2.
We consider the direct limit and inverse limit of operator spaces, and use it to define the infinite Haagerup tensor product of operator spaces.
本文用算子空间的定向极限和逆向极限定义了算子空间的无限Haagerup张量积;证明了Hilbert 列空间的无限Haagerup张量积与 Hilbert空间的无限张量积是相容的。
4)  subspace algorithm
子空间算法
1.
New subspace algorithm for blind channel estimation in OFDM systems;
一种新的OFDM系统信道盲估计的子空间算法(英文)
2.
At last,making use of the CP in OFDM,a blind subspace algorithm.
建立了2发1收的ST-OFDM系统模型;利用空时编码的特点,对发射信号采用恒模复调制,引入周期相关特性,将各子信道分开进行估计;利用循环前缀引入的信息冗余给出子空间算法,实现盲信道估计。
3.
Because the transmission equation of OFDM systems does not exactly have the desired structure to directly derive a subspace algorithm, a new matrix transform on the equation is proposed, then a blind subspace-based algorithm is developed.
利用循环前缀(CP)引入的信息冗余,提出一种利用接收信号的二阶统计特性实现正交频分复用(OFDM)系统信道盲估计的子空间算法。
5)  spatial moment operator
空间矩算子
1.
Method of subpixel location based on 2~(nd) spatial moment operators is deduced.
首先介绍了火炮身管弯曲度测量系统的构成,然后阐述了基于二阶空间矩算子的亚像素定位算法,在此基础上对激光光斑中心位置进行高精度测量。
6)  subspace method
子空间算法
1.
Based on the subspace method, this paper presents a new technique for the blind equalization of multiple-input multiple-output linear systems whose channel impulse has finite support of the same length.
基于基本的子空间算法,研究了一种实现具有相同有限长冲激响应的多输入多输出线性系统盲均衡的方法。
补充资料:凹算子与凸算子


凹算子与凸算子
concave and convex operators

凹算子与凸算子「阴~皿d阴vex.耳阳.勿韶;.留叮.肠疽“‘.小啊j阅雌口叹甲司 半序空间中的非线性算子,类似于一个实变量的凹函数与凸函数. 一个Banach空间中的在某个锥K上是正的非线性算子A,称为凹的(concave)(更确切地,在K上u。凹的),如果 l)对任何的非零元x任K,下面的不等式成立: a(x)u。(Ax续斑x)u。,这里u。是K的某个固定的非零元,以x)与口(x)是正的纯量函数; 2)对每个使得 at(x)u。续x《月1(x)u。,al,月l>0,成立的x‘K,下面的关系成立二 A(tx))(l+,(x,t))tA(x),00. 类似地,一个算子A称为今单(~ex)(更确切地,在K上“。凸的),如果条件l)与2)满足,但不等式(*)用反向不等号代替,并且函数粉(x,t)<0. 一个典型的例子是yP‘KOH积分算子 通rx‘t、1二f天(t.:,x(s))山, G它的凹性与凸性分别由纯量函数介(t,s,。)关于变量u的凹性与凸性所确定.一个算子的凹性意味着它仅仅包含“弱”的非线性—随着锥中的元素的范数增加,算子的值“慢慢地”增加.一般说来,一个算子的凸性意味着,它包含“强”的非线性.由于这个理由,包含凹算子的方程在许多方面不同于包含凸算子的方程;前者的性质类似于相应的纯量方程,而不同于后者,后者关于正解的唯一性定理是不成立的.
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条