1) model/drift region length
模型/漂移区长度
2) drift length
漂移长度
3) drift model
漂移模型
1.
Drift Model for Ship out of Control at Sea;
海上失控船舶漂移模型研究
2.
Precisely determining the drift model coefficients is the key to successful long-time operation with the na- vigation systems.
陀螺仪的漂移误差是空间稳定惯性导航系统的主要误差源,对漂移模型系数的准确辨识是保证系统实现长时间、高精度自主导航的关键。
3.
It points out that the chose of distribution parameter C o and drift velocity V vj may have significant effect on the result of static and dynamic analysis of the system, when one dimensional two phase flow drift model with conservation equations for mass, steam, energy and momentum was used.
指出在采用带有质量，蒸汽质量，能量及动量守恒方程的一维两相流漂移模型分析时，空泡份额分布参数Ｃｏ及漂移速度Ｖｖｊ的选择对系统稳态及动态分析结果都会产生很大的影响。
5) Drift flux model
漂移流模型
1.
Drift flux model is prevailing for the prediction of void fraction in two-phase flow,whereas distribution parameter C0 and drift velocity ugj of the model are an issue argued by different researches until now.
漂移流模型在两相流空泡率计算中处于非常重要的地位,长期以来,研究者对模型中分布参数及漂移速度的确定持不同的观点。
2.
In the calculation of void fraction, Zuber-Findlay drift flux model is the most famous one.
在计算空泡率的众多模型中 ,Zuer Findlay漂移流模型目前应用最为广泛。
3.
Based on the theory of bifurcation and its DERPAR algorithm, the static bifurcation solution diagram of a typical twophase natural circulation system is analyzed using drift flux model, and compared with the results of homogenous model.
基于分岔理论及其DERPAR数值方法,运用漂移流模型分析典型两相自然循环系统的静态分岔解图,并与均相流模型的结果进行了比较。
6) wavelength-temperature shift
波长-温度漂移
补充资料：变形区长度
变形区长度
length of deformation zone
b ianxingqu ehangdu变形区长度(length of deformation:one) 轧制时轧件同轧辊接触弧的水平投影长度，一般以l表示，l=双sina，式中R为轧辊半径，a为咬入角。从几何关系还可以求得l与R及压下量从的关系为l /_.，从2，_劫2.__L___.，~~:，、，~=心R从一二笋.，由于岑~相对于R助小得多，故计算 V-一4’一一4’一’‘’--一一~一，一，·~中均用其近似值l、翻丫天瓦。 (余望)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条