1) storage cell
铅晶体蓄电池
1.
The technical condition for electrode of lead crystal storage cell were given, The effects of weight percent of Ph: Cd in the lead- cadmium coating on the surface morphology and electrochemical behavior of PbO2 electrode were investigated by scanning electron microscopy and chemical analysis.
简述了铅晶体蓄电池电极的制备技术,通过扫描电镜及化学分析研讨了在Pb-Cd沉积层中,Pb:Cd的质量百分比对PbO2电极表面形态及电化学特性的影响。
2) lead crystal
铅晶质
3) Lead-crystal electrode
铅晶电极
4) PbWO_4 crystal
钨酸铅晶体
1.
Simulations on the electronic structure and optical properties for the perfect raspite-structured PbWO_4 crystal;
斜钨矿结构钨酸铅晶体电子结构和光学性质的模拟计算
2.
2)MeVγ-ray of the PbWO_4 crystals is about 1∶2,the ratio of n/γ of the PbWO_4 crystals is about 1∶6 and the decay time of the PbWO_4 crystals is about 6ns.
2MeV)、DPF中子源和直线拟合方法,通过实验测定和理论计算,得到了钨酸铅晶体对ST-401闪烁体的γ相对灵敏度(约为1∶2),晶体的中子与γ灵敏度之比(约为1∶6)和晶体的衰减时间(约为6ns)。
3.
But the application of PbWO_4 crystal is limited to high-energy physics because of its low light yield.
因此,提高钨酸铅晶体的光产额以使其在PET装置等低能领域获得应用已成为近年来钨酸铅晶体的研究热点。
5) PWO crystal
钨酸铅晶体
1.
The performances of PWO crystals obtained are as follows: optical transmittance more than 60% at 420nm and more than 25% at 360nm, light yield more than 9 p.
用改进的垂直坩埚下降法成功地生长了高质量的钨酸铅晶体,晶体毛坯的尺寸为28min×28mm×360mm;晶体的生长工艺参数为:籽晶取向[001];下降速度 0。
2.
This paper describes the scintillating properties of lead Tungstate Crystal (PWO), including excitation spectrum, fluorescent spectrum, transmission, light yield, decay time, radiation damages and recovery , light collection un-uniformity, timing resolution and energy resolution of PWO crystal matriex for high energy photons and electrons.
叙述了国产钨酸铅晶体(PWO)的主要性能,包括激发光谱和发射光谱,透过率,光产额,发光衰减时间,辐照损伤及其恢复,收光均匀性,以及时间分辨率和PWO晶体阵列对高能光子的能量分辨。
6) lead tungstate crystal
钨酸铅晶体
1.
Lead tungstate crystal (PWO), a key component of the electromagnetic calorimeter of CMS, must meet high quality requirements in order to attain the claimed energy resolution.
钨酸铅晶体是新一代对撞机谱仪CMS的电磁量能器的主体。
2.
results for several full size (23 cm length) lead tungstate crystals under Co 60 γ ray side irradiating, investgating the light yie.
大型强子对撞机 (LHC)运行时具有很高的辐射背景 ,为达到所要求的电磁量能器的测量精度对研制中的钨酸铅晶体的抗辐照性能提出了很高的要求 。
参考词条
硒化铅晶体
硫化铅晶体
碲锡铅晶体
铅晶质玻璃
无铅晶质玻璃
掺铋钨酸铅晶体
掺钇钨酸铅晶体
掺Gd钨酸铅晶体
掺镧钨酸铅晶体
掺La钨酸铅晶体
硒化锡铅晶体
低温灌肠
双黄杀毒退烧颗粒剂(SHTK)
补充资料:阀控密封式铅酸蓄电池
分子式:
CAS号:
性质: 用允许气体逸出的限压阀(单向排气阀)密封的一种铅酸蓄电池。其特点是采用特殊的铅基合金如铅钙合金和低锑合金制造板栅,以减少气体的析出,采用超细玻璃纤维隔板和贫液电解质,造成两极之间有气相“通道”,以利于正极产生的氧气向负极扩散并与负极的活性物质海绵状金属铅相化合。限压阀一般在电池内部压力高于外界压力1~200kPa时能够可靠地开启和关闭。多用作应急照明设备、不间断电源、移动测量设备、信号系统、电信装置和计算机等的直流电源。汽车蓄电池也有逐步改用这种蓄电池的趋势。
CAS号:
性质: 用允许气体逸出的限压阀(单向排气阀)密封的一种铅酸蓄电池。其特点是采用特殊的铅基合金如铅钙合金和低锑合金制造板栅,以减少气体的析出,采用超细玻璃纤维隔板和贫液电解质,造成两极之间有气相“通道”,以利于正极产生的氧气向负极扩散并与负极的活性物质海绵状金属铅相化合。限压阀一般在电池内部压力高于外界压力1~200kPa时能够可靠地开启和关闭。多用作应急照明设备、不间断电源、移动测量设备、信号系统、电信装置和计算机等的直流电源。汽车蓄电池也有逐步改用这种蓄电池的趋势。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。