1) calcination system
预烧制度
1.
The performance of PTC material is sensitive to the calcination system.
ＰＴＣ材料性能对预烧制度十分敏感，通过大量实验，研究了预烧工艺条件对低阻ＰＴＣ热敏陶瓷性能的影响。
2) calcining temperature
预烧温度
1.
The effect of calcining temperature on the microstructure and magnetic properties of high permeability MnZn ferrites;
预烧温度对高导磁率MnZn铁氧体微结构和磁性能的影响
2.
The calcining temperature was in the range from 950 ℃ to 1100℃.
对CCTO陶瓷进行物相分析,并测试了20Hz-1MHz频率范围和25～150℃温度区间的介电性能和阻抗谱,详细研究了预烧温度对CCTO陶瓷烧结性能、晶体结构和介电性能的影响。
3.
The effects of calcining temperature on sintering,microstructure and electromagnetic properties of NiCuZn ferrites for multilayer chip inductor(MLCI) are investigated.
研究了预烧温度对多层片式电感器用NiCuZn铁氧体的烧结、显微结构和电磁性能的影响。
3) pre-sintering temperature
预烧温度
1.
Research on pre-sintering temperature of BaO-Y_2O_3-5TiO_2 system microwave dielectric ceramic;
BaO-Y_2O_3-5TiO_2系微波介质陶瓷预烧温度研究
2.
The influence of pre-sintering temperature on the microstructure and properties of nano-composite Ti(C,N)-based eermets has been studied using SEM,TEM and EDX.
用真空预烧+热等静压处理工艺制备了纳米复合Ti(C,N)基金属陶瓷,用SEM和TEM／EDX研究了预烧温度对纳米复合Ti(C,N)基金属陶瓷显微组织和性能的影响。
3.
X-ray diffraction (XRD) and scanning electron microscopy (SEM) were used to investigate the influence of pre-sintering temperature on the pre-sintered phases and microstructure of sintered Mn-Zn ferrite.
用X射线衍射(XRD)仪和扫描电子显微镜(SEM)研究了预烧温度对铁氧体预烧相及烧结显微结构的影响。
4) calcined temperature
预烧温度
1.
Research on the calcined temperature of ceramics based on (1-x)NBT-xBaTiO_3 during the preparation;
(1-x)NBT-xBaTiO_3系陶瓷材料制备过程中预烧温度的研究
2.
The effect of salt quantities and calcined temperature on microstructure and morphology of Bi_4Ti_3O_~12 powder was investigated.
研究了预烧温度及熔盐含量对粉体形貌及显微结构的影响。
5) presintering temperature
预烧温度
1.
The effects of presintering temperature on microstructure,density,thermal shock resistance,bend strength and corrosion resistance of inert anodes of NiFe_2O_4 spinel with additives TiO_2、MnO_2 are researched.
研究了预烧温度对掺杂 TiO_2、MnO_2的镍铁尖晶石惰性阳极的微观结构、密度、抗热震性、抗弯强度、抗腐蚀性的影响。
2.
It was obviously observed that with increasing presintering temperature,initial permeability increases at first and then decreases(peak value at Tp=1250℃) ,larger ε′ and lower ε′′ were obtained at lower frequency,but the peak value of ε′′ moves towards l.
结果表明,随着预烧温度的升高磁导率先增大后减小(Tp=1250℃时为峰值),介电常数增大,介电损耗减小(低频段),但介电损耗峰增高且向低频移动;随着烧结温度的升高,磁导率的总变化趋势是先增大后减小,截止频率增高。
3.
The effect of sintering temperature and presintering temperature on the magnetic properties of ferrites was investigated.
研究了烧结温度与预烧温度对NiZn铁氧体性能的影响。
6) pre-sintered density
预烧密度
补充资料：预度
1.犹预测。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条