1) combustion schedule
燃烧制度
1.
can be realized on the basis of rational combustion schedule,option of optimum combustion parameters, improvement of combustion operation and automatized combustion con-trol.
新建的攀钢４号高炉外燃式热风炉，实现高风温的关键是研究合理的燃烧制度，选择最佳燃烧操作参数，改进燃烧操作，实现自动控制燃烧，研究认为，采用空燃比为０。
2) firing rate
燃烧强度，燃烧率
3) combustion temperature
燃烧温度
1.
The effects of nitrogen purity and pressure,combustion temperature,diluents content and the porosity were studied during the process.
研究结果表明:只要控制反应中的工艺参数,就可以采用自蔓燃得到不同相含量的Si3N4粉体;考虑到燃烧温度(Tcom),在氮化硅粉体的合成过程中,涉及到3个反应机制:低温机制,中温机制,高温机制;氮气压力下硅粉的自蔓燃合成反应,必须要引入Si3N4稀释剂,来控制反应温度和反应速度,获得不同相含量的粉体;NH4Cl在反应中分解,为反应提供了NH3,并与硅粉反应;压坯气孔率控制在30%~70%,否则反应不能进行。
2.
The influence of pressure, diameter and preheating temperature of green-pellet on combustion temperature (T_c) during preparing Al-Ti-C master alloy and the microstructure of synthesized product has been investigated.
采用自蔓延高温合成(SHS)技术制备出了一种用于铝及铝合金晶粒细化的AI-Ti-C中间合金,并研究了压坯密度、压坯直径、预热温度对自蔓延高温合成Al-Ti-C中间合金时的燃烧温度及微观组织结构的影响。
3.
The effect of CaO/MgO ratios on the efficiency of sulfur fixation was studied under the different combustion temperatures and the quantities of the sulfur-fixing agents.
通过对不同燃烧温度和固硫剂添加量下CaO/MgO之比与固硫率之间关系的研究发现,燃烧温度相同而CaO/MgO之比不同时,固硫率不同;燃烧温度不同时,最佳CaO/MgO之比也不同,而且随温度升高而向CaO增多、MgO减少的方向变化。
4) burning temperature
燃烧温度
1.
Influence of cigarette smoking parameters on burning temperature and delivery levels of smoke constituents;
抽吸参数对卷烟燃烧温度及主流烟气中某些化学成分的影响
2.
With action of catalyst it increases burning temperature, decreases energy consumption.
由于催化剂的作用，这种火盖可提高燃烧温度、降低 能耗、改善燃烧废气带来的环境污染。
3.
The burning temperature and explosive pressure of thirteen kinds of hydrocarbon gases was computed under various original conditions.
对于压力容器内的烃类气体与空气的混合物，按球面逐层绝热燃烧模型，编制了电算程序ＤＵ ＴＧＢ１，在不同初始条件下计算了１３种烃类气体的燃烧温度与爆炸压力，用本文实验值及文献值与之比较，燃烧温度的计算偏差为１１。
5) burning rate
燃烧速度
1.
Using the global model for the oil tank fires developed by authors, the variation of the burning characteristics, such as the burning rate, the flame height, the flame pulsation frequency, and the mean flame temperature were obtained.
本文利用自行建立的油罐火灾燃烧特性通用模型,计算得到了燃烧速度、火焰高度,火焰跳动频率和平均温度等油罐燃烧特性的变化规律,并深入探讨了油品燃烧速度在油罐直径、风速、环境温度和油位等因素影响下的变化趋势。
2.
The influence of the ratio of composition Mg/KNO 3 on the burning rate,near-infrared radiation intensity and visible light intensity is determined by experiment in this paper.
通过实验确定了镁/硝酸钾药剂的配比对燃烧速度、近红外辐射强度和可见光强度的影响。
3.
7 m,the regularity of instantaneous burning rate and average burning rate were acquired.
燃烧速度是油罐火灾中决定火焰温度和辐射热的重要参量,其变化规律也决定着火灾中灭火预案及战术的制定。
6) Combustion speed
燃烧速度
1.
The influences of ratio of infrared composition Mg_4Al_3/PTFE on the combustion speed,emission intensity and special emission energy are introduced in this paper.
文章介绍了镁铝合金/聚四氟乙烯(Mg4Al3/PTFE)红外诱饵剂的配比对燃烧速度、辐射强度和质量辐射能量的影响。
2.
5 at Banshan Power Plant an analysis and a comparison was conducted of the combustion speed of coal water slurry (CWS) and pulverized-coal coke particles.
通过茂名热电厂 2号燃用水煤浆锅炉与半山电厂 5号煤粉炉满负荷燃烧试验 ,对水煤浆 (CWS)与煤粉焦炭颗粒进行燃烧速度的分析、比较。
3.
The specific radiation energy, the linear combustion speed and the cooling time of infrared radiation after combustion were obtained from a set of experiments, and then the infrared radiation intensity was calculated and discussed.
首先建立了镁/聚四氟乙烯药柱在恒面和减面燃烧条件下红外辐射强度的计算模型,通过一系列实验测定了药柱的比辐射能、线燃烧速度以及冷却时间,最后计算了药柱燃烧时的红外辐射强度,并与实验结果进行了比较。
补充资料：沸腾床燃烧(见流化床燃烧)
沸腾床燃烧(见流化床燃烧)
boiling-bed combustion:see fluidized-bed combustion
沸腾床燃烧(boiling一bed eombustion)见流化床燃烧。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条