1) sequential truncated inspection
![点击朗读](/dictall/images/read.gif)
序贯截尾检验
1.
Based on the definition of Bayes post test risk,Bayes sequential and sequential truncated inspection methods have been made a study systematically,and then the project design approaches of Bayes sequential and sequential truncated inspection have also been given concisely.
基于Bayes验后风险定义 ,系统研究了Bayes序贯检验和序贯截尾检验方法 ,给出了简洁实用的Bayes序贯检验和序贯截尾检验工程设计方法 ,对试验工程有较大的借鉴意
2.
In accordance with existing some hard problems in the use of sequential and sequential truncated inspection and brought the definite error to the test,optimization design of sequential and sequential truncated inspection scheme for missile test is carried out by using the method of Monte Carlo random simulation and the idea of modern optimization,and the result is satisfactory.
针对序贯检验和序贯截尾检验方法在工程实际应用中存在的一些难以解决的问题 ,且给试验带来一定的误差 ,采用蒙特卡洛随机模拟方法和现代优化设计思想 ,对战术导弹试验中的序贯检验和序贯截尾检验方案进行优化设计 ,取得了较好的效果 。
2) truncated sequential posterior odd test
![点击朗读](/dictall/images/read.gif)
截尾序贯验后加权检验
1.
It is very important to select a truncating point in the truncated sequential posterior odd test (SPOT), but there is no efficient method to solve the problem up to now.
选取截尾点是截尾序贯验后加权检验很关键的一步,目前理论上尚无有效的选取方法。
3) sequentially censored testing
![点击朗读](/dictall/images/read.gif)
序贯截尾试验
4) sequential truncation
![点击朗读](/dictall/images/read.gif)
序贯截尾
1.
The schemes introduced in this paper are Type-I censoring and sequential truncation.
![点击朗读](/dictall/images/read.gif)
在生产方、使用方风险及MTBF值同等条件下,对定时截尾与序贯截尾2种试验方案的优缺点、基本原理和方法等进行了对比分析。
5) curtailed inspection
![点击朗读](/dictall/images/read.gif)
截尾检验
6) sequential test
![点击朗读](/dictall/images/read.gif)
序贯检验
1.
,design an ameliorate sequential test(if c 1t <s,assume c 1t =c 1t ;if c 1t ≥s,assume c 1t =s):n 1 (0,c 11 ),n 2 (1,c 12 ),.
利用Wald的序贯概率比检验中接收产品时对应的批检验数 :n1 (0 ,c1 1 ) ,n2 (1 ,c1 2 ) ,… ,nk (k - 1 ,c1k) ,… ,设计出一种改进型序贯检验 (其中当c1t
2.
Aiming at this problem,a new trajectory consistence evaluation method based on probability circle and sequential test was recommended according to mathematical statistics,shooting theory and the theory of sequential test.
基于数理统计、射击理论和序贯试验理论,提出了一种基于概率圆序贯检验的弹道一致性评定新方法。
补充资料:不合格百分率计数检验的序贯抽样方案
不合格百分率计数检验的序贯抽样方案
sequential sampling plans for inspection by attributes for percent nonconforming
加hege比ifen.o Jishu Jianvan dex叩uanC伙泪四叩fa叩’On不合格百分率计数检验的序贯抽样方案(se-quenti吐~plingp】川15 for inspection场attributesforpe二ni nonconfo丽ng)逐个地(或成组地)抽取个体,但事先并不固定它们的个数,根据事先规定的规则,直到可以做出接收或拒收批的决定为止。作为代表性的是IEC 1 123:l卯l标准。 设在n.抽试产品中出现;个不合格,且抽样方案给出:,h两数。判决规则如下:①如;n一h〕r,则接收;②如:n一h
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条