1) sequential testing analysis
序贯检验分析
1.
The mathematical theory of sequential testing analysis is given and its application in biological medicine is discussed.
给出了序贯检验分析的数学理论，讨论了序贯分析方法在生物医学中的应用模型。
2) sequential test
序贯检验
1.
,design an ameliorate sequential test(if c 1t <s,assume c 1t =c 1t ;if c 1t ≥s,assume c 1t =s):n 1 (0,c 11 ),n 2 (1,c 12 ),.
利用Wald的序贯概率比检验中接收产品时对应的批检验数 :n1 (0 ,c1 1 ) ,n2 (1 ,c1 2 ) ,… ,nk (k - 1 ,c1k) ,… ,设计出一种改进型序贯检验 (其中当c1t
2.
Aiming at this problem,a new trajectory consistence evaluation method based on probability circle and sequential test was recommended according to mathematical statistics,shooting theory and the theory of sequential test.
基于数理统计、射击理论和序贯试验理论,提出了一种基于概率圆序贯检验的弹道一致性评定新方法。
3) sequential analysis
序贯分析
1.
Sequential analysis of The addition of levamisole to prednisolone to treat intractable erosive oral lichen planus;
左旋咪唑与强的松联合用药治疗顽固性糜烂型OLP的序贯分析
2.
To deal with this issue,under the theories of sequential analysis and multiple hypothesis test,we introduce in this paper a novel method,Sequential Multiple Decision Procedure(SMDP),which can be used for testing and grouping large numbers of makers with sequentially varying samples size.
针对此问题,本文根据序贯分析和多重假设测验的理论,介绍了可用于变化样本容量下对大量标记同时进行测验分组的序贯多重决策过程的原理和方法,探讨了该方法在实际应用中的计算精度和计算量优化等关键问题及相应的解决方案,最后以1套包括5 841个SNP和87个细胞系的药物遗传学实验数据进行实例分析,并与传统的测验结果比较,表明了序贯多重决策过程在实际应用中的优点和可行性。
3.
Based on the 2 models, 2 algorithms are illustrated by the use of sequential analysis and most powerful test.
为此，本文在提出两个概率诊断模型的前提下，利用序贯分析及最优势检验等统计分析方法分别给出这两个模型的诊断算法
4) Sequential analysis
贯序分析
5) Bayes sequential test
Bayes序贯检验
1.
According to very small sample of the weapon system test,the Bayes sequential test method on MTBF of weapon system is researched.
针对武器系统试验鉴定中显著具有的小子样的特点,研究了武器系统平均故障间隔时间(MTBF)的Bayes序贯检验方法,推导了检验模型,平均试验数计算公式、定时和定数截尾实际风险计算公式,并给出了算例。
6) sequential testing diagram
序贯检验图
补充资料：不合格百分率计数检验的序贯抽样方案
不合格百分率计数检验的序贯抽样方案
sequential sampling plans for inspection by attributes for percent nonconforming
加hege比ifen.o Jishu Jianvan dex叩uanC伙泪四叩fa叩’On不合格百分率计数检验的序贯抽样方案(se-quenti吐~plingp】川15 for inspection场attributesforpe二ni nonconfo丽ng)逐个地(或成组地)抽取个体，但事先并不固定它们的个数，根据事先规定的规则，直到可以做出接收或拒收批的决定为止。作为代表性的是IEC 1 123:l卯l标准。 设在n.抽试产品中出现;个不合格，且抽样方案给出:，h两数。判决规则如下:①如;n一h〕r，则接收;②如:n一h
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条