1) point light source
点光源
1.
Measurement of wedge angle of plate using interference of point light source;
利用点光源干涉测量平板的楔角
2.
In the new wire diameter online measurement system proposed, laser diode was used as the point light source to emit spheric waves passing through a wire.
提出一种细丝直径在线测量方法,利用半导体激光作为点光源,发出球面波;通过细丝后在其后菲涅耳衍射区留下阴影,测量阴影宽度可得细丝直径;同时,利用两个相距一定距离的点光源对同一细丝投影,测量两个投影之间的距离可得细丝位置的晃动量,从而校正直径测量值。
3.
Based on the principle that spherical ware comes from the point light source, isoclinic and isopach interference and their chart in the experiment of Michelson interferometer are discussed, emphasizing the relationship between them.
本文从点光源发出球面波原理出发,讨论了迈克尔逊干涉仪实验中的等倾与等厚干涉及其干涉图样,突出了二者的关系。
2) point source
点光源
1.
Based on the theory of Fresnel diffraction,the diffraction patterns were analyzed when the point source was placed in front of focal plane,at focal plane and behind focal plane.
利用菲涅耳衍射理论,讨论了无衍射成像系统中点光源在透镜焦点及焦点前后所产生的无衍射光斑形式。
3) pointolite
['pɔintəlait]
点光源
1.
The wavelength value of He-Ne Laser tends to be big when measured with pointolite non-localized interference of Michelson interferometer.
用迈克尔逊干涉仪的点光源非定域干涉测氦氖激光的波长时 ,其值总是偏大。
2.
The relationship of the entrance angle and the height of the light at the illuminanted surface was used in the isotropic pointolite system.
在各向同性的点光源系统中,利用光线在照明面上的高度与入射角的关系,用Zemax软件设计照度分布均匀的系统。
3.
The light distribution of pointolite, interference fringe and its characters are discussed by theory of interference of light on the condition of plate thickness being non uniform.
运用光的干涉理论 ,分别讨论了点光源在平板厚度不均匀情况下的光强分布、条纹及特征 ,分析了多光束干涉对光强分布和条纹的影响 ,并推导出测量平板楔角的一种新方法 。
4) spotlight
[英]['spɔtlaɪt] [美]['spɑt'laɪt]
点光源
1.
Random phase encoding achievement of color images under spotlight illumination;
点光源照射下彩色图像随机相位编码的实现
2.
The characteristic of this method is:under the spotlight illumination,one random phase mask and the phase factor of spherical wave are used to realize image encryption in the Fresnel domain.
为了简化系统设置,根据双随机相位编码加密方法中两块相位掩模的作用,提出用点光源照射系统,结合球面波的相位因子,实现了只用一块相位掩模在菲涅耳域进行图像加密。
5) Point source of light
点光源
1.
The control principle of the scenery picture,that is projected by point source of light,the consist of control system hardware,implements means and the software system are introduced in bomb by optic collimator.
介绍了光学轰炸中点光源视景图像的控制原理、控制系统的硬件组成、实现方法及软件系统。
6) dot-matrix light
点阵光源
补充资料:闭式单点、双点压力机
| |||||||
主要参数内容 | 国际先进 | 国内先进 | 国内一般 | 国内落后 | 评定方法及说明 | ||
(一)加工精度 | 参照GB10924-89、GB10933-89、JB5200-91 | ||||||
1、滑块下平面对工作台上平面的平行度(mm) | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.02+0.10/100×滑块下平面的被测长度 | |||||||
2、滑块行程对工作台上平面的垂直度 | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.05+0.02/100×滑块行程长度 | |||||||
(二)结构性能 | |||||||
1、离合器、制动器接通率,当滑块行程次数≤16次/分时为70%,≤25次/分时为60%,≤45次/分时为50% | 大于规定值10% | 大于规定值 | 达到规定值 | 达不到规定值 | |||
2、液压超负荷保险装置、微调装置、吨位指示器 | 全部具有 | 全部具有 | 部分具有 | 没有 | |||
(三)噪声dB(A) | |||||||
1、公称力≤400kN | ≤85 | ≤87 | ≤88 | >88 | |||
2、公称力>400kN | ≤87 | ≤88 | ≤90 | >90 |
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条