1) point-line meshing
点线啮合
1.
Comparing with normal involute gear transmission,point-line meshing gear transmission has a serial of advantages: good meshing capability,small abrasion,high efficiency,low noise,great carrying capacity,high intension,long life etc.
介绍了点线啮合齿轮的基本理论,分析了其传动的参数选择和几何尺寸,通过实验验证和工程应用,发现点线啮合齿轮传动与常规的渐开线齿轮传动相比,具有跑和性能好、磨损小、效率高、噪声低、承载能力大、强度高、寿命长等一系列优点,具有广阔的应用前景。
2) point-line meshing gear
点线啮合齿轮
1.
Development of DQJ point-line meshing gear series reducer;
DQJ点线啮合齿轮减速器的研制
2.
Use SolidWorks as modeling software,through SolidWorks API which is its further development interface,and VB,developed a calculation and 3D modeling system for spur or helical point-line meshing gears,which will improve the efficiency and precision of designing,decrease the cost and have broad application prospect.
介绍了点线啮合齿轮的基本理论及其齿廓曲线方程,以SolidWorks为造型软件,通过二次开发接口SolidWorks API,应用VB语言开发了点线啮合直齿、斜齿齿轮设计计算及三维造型系统,提高了设计效率和精度,降低了设计成本,具有广阔的应用前景。
3.
The bending strength of an involute gear and the point-line meshing gear is calculated with this software.
运用此软件对相同参数的渐开线齿轮与点线啮合齿轮进行弯曲强度的有限元精确计算,得出点线啮合齿轮比渐开线齿轮弯曲强度提高11。
3) point contact
点啮合
1.
Based on the unified mathematical model,it put forward the equivalent roller concept and showed the correspondence relationship between an equivalent roller and actual roller on the basis of the design concept of controllable point contacts of a spatial cam mechanism.
在滚子统一数学模型的基础上,基于可预控空间凸轮机构点啮合改进设计思想,提出了当量滚子的概念,并给出了当量滚子和实际滚子之间的对应关系。
4) two-point gear-meshing
两点啮合
1.
Different types of multi-point gear-meshing flexible transmission are introduced in the paper, the two-point gear-meshing construction is put forward, and the designing problems is preliminary researched.
介绍国内外现有多柔传动装置的型式,提出采用两点啮合的多柔传动结构,并对其设计问题进行初步探讨。
5) point-contact
点啮合
1.
Sphere-conical roller globoid cam point-contact mechanism and the application;
点啮合球锥滚子弧面凸轮机构及应用
6) meshing pitch point
啮合节点
补充资料：电磁线点摄开关
电磁线点摄开关(Solenoid release)是供新闻摄影照相机等使用，系列用电磁线的点摄开关。只要能延长线，可在较远处打开快门。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条