1) Mass injection and Precooling
射流预冷却
2) fluidic cooling
射流冷却
1.
In this paper,it introduces some cutting and cooling methods in green manufacturing, and also makes an analysis and a comparison of these methods, and makes further analysis of the green fluidic cooling technology.
介绍了绿色制造中的几种切削方法和冷却方法,对几种方法进行了分析、比较,并对“绿色射流冷却技术”进行了进一步的探讨,认为此方法是众多绿色切削工艺中较理想的一种。
3) atomizing jet cooling
雾化射流冷却
1.
Based on the experiments of atomizing jet cooling the Ti alloy(Ti6Al4V) specimen with fixed pressure,wind and different quantities of water,this paper discussed the performance and regulation of heat-transfer when atomizing jet cools Ti alloy specimen with fixed pressure,wind and little water.
文中以定压、定量风和不同含量水相组合时射流冷却被加热的钛合金(Ti6A l4V)试件的实验为基础,探讨了定压力、定量风和微量水相综合雾化射流冷却钛合金试件时的换热性能和规律。
6) flood coolant
[机]射流冷却剂
补充资料：设备安装前的准备工作——设备的预装配与预调整
设备安装前的准备工作——设备的预装配与预调整 | ||
|
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条