1) cryogenic pneumatic mist jet cooling
低温气体雾化射流冷却
1.
Analysis and experimental study of heat transfer in cryogenic pneumatic mist jet cooling
液滴低温气体雾化射流冷却换热理论分析与实验研究
2) cryogenic pneumatic mist jet impinging
低温气动喷雾射流冲击冷却
1.
To solve the problems of workpiece-burn in grinding of titanium alloys,a new high(efficiency) cooling technology—cryogenic pneumatic mist jet impinging cooling technology(CPMJI) was offered.
针对钛合金磨削加工中容易造成工件烧伤及加工质量不易保证的难题,提出了一种新的高效冷却技术———低温气动喷雾射流冲击冷却技术,并依据此思想开发出一套低温气动喷雾射流冲击冷却系统,将其应用于钛合金的磨削加工中。
3) atomizing jet cooling
雾化射流冷却
1.
Based on the experiments of atomizing jet cooling the Ti alloy(Ti6Al4V) specimen with fixed pressure,wind and different quantities of water,this paper discussed the performance and regulation of heat-transfer when atomizing jet cools Ti alloy specimen with fixed pressure,wind and little water.
文中以定压、定量风和不同含量水相组合时射流冷却被加热的钛合金(Ti6A l4V)试件的实验为基础,探讨了定压力、定量风和微量水相综合雾化射流冷却钛合金试件时的换热性能和规律。
5) air-jet cooling
气体射流冷却
6) spray cooling
雾化喷射冷却
1.
The mechanism of heat transfer in spray cooling is complicated, and most theories hitherto are immature.
雾化喷射冷却的换热机理十分复杂,目前其研究还很不成熟。
2.
The thickness and behavior of the liquid film on the surface of the wall is the most important to study heat transfer and it mechanism for spray cooling.
冷却壁面上液膜的特性行为与厚度直接关系到雾化喷射冷却的深入研究。
补充资料：低温
低温
hypothermia
低温状态下脑组织对缺氧的耐受性明显增加。体温低于37℃时，每减低1℃，脑组织代谢率减少6.7%，颅内压减低5.5%，在人工呼吸、心脏按压的同时或稍后应给予降温处理，可采用正规冬眠疗法使体温降至肛温35℃左右，目前尤为重视头部局部降温，戴冰帽，头温降至32℃左右，重症要降温3～5天。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条