1) length ofcast-rolling-zone
铸轧区长度
2) set-back
[英]['setbæk] [美]['sɛtbæk]
轧制区长度
3) casting-rolling zone
铸轧区
1.
Effects of roller-shell material on the magnetic intensity in casting-rolling zone;
辊套材料对铸轧区磁感应强度影响的实验研究
2.
The calculation formula of total casting-rolling zone length is established,The exactitude for theoretical formula are proofed by experiment.
本文对原冷凝区长度公式作了修正,并建立了总铸轧区长度的计算式。
4) Cast-rolling zone
铸轧区
1.
The edge cracks of aluminum continuous cast-rolled strips result from that the cast-rolling zone is a little higher,the structure of tips is not reasonable,and the quality of cast-rolling roller is not good.
铝铸轧板坯产生严重裂边的主要原因是，铸轧区偏高、供料嘴结构不合理和铸轧辊质量不佳。
5) setback
[英]['setbæk] [美]['sɛt'bæk]
铸轧区
1.
Effect of the setback, casting speed, casting temperature etc on the saparatingforce, strip quality were studied and thier mechanism were discussed on the basisof experience.
讨论了铸轧区、铸轧速度、铸轧温度等对轧制力、铸轧板坯质量的影响，并根据实践对影响机理进行了探讨。
6) roll-casting speed
铸轧速度
1.
The influence of roll-casting speed and casting temperature on solidification is also analyzed.
采用有限差分法对双辊式带钢铸轧过程进行了三维数值模拟,分析了铸轧速度和浇铸温度对铸坯凝固过程的影响,得出了铸轧速度、铸轧辊径和带厚之间的关系以及适宜的浇铸温度,从而为带钢的稳定生产和控制带钢铸轧过程打下理论基础。
补充资料：变形区长度
变形区长度
length of deformation zone
b ianxingqu ehangdu变形区长度(length of deformation:one) 轧制时轧件同轧辊接触弧的水平投影长度，一般以l表示，l=双sina，式中R为轧辊半径，a为咬入角。从几何关系还可以求得l与R及压下量从的关系为l /_.，从2，_劫2.__L___.，~~:，、，~=心R从一二笋.，由于岑~相对于R助小得多，故计算 V-一4’一一4’一’‘’--一一~一，一，·~中均用其近似值l、翻丫天瓦。 (余望)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条