说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 风区长度
1)  wind region length
风区长度
1.
After the Yangtse gorges shed area stores water normally, wind region length will increase and wind and wave will increase highly too.
三峡库区正常蓄水后风区长度会大幅增加,风浪波高也随之增加,为寻求适合库区正常蓄水后的风浪波要素计算方法,通过对国内外常用计算风浪波要素公式的研究分析,提出的官厅公式适合于库区大范围的风浪要素计算,计算结果与实际情况吻合良好。
2)  equivalent wind area length
等效风区长度
3)  length of tuyere raceway
风口回旋区长度
1.
The article has intuitively determined the length of tuyere raceway and burning rate of blowing pulverized coal by the sampling analysis of tuyere coke.
文章通过炉前风口焦取样分析,直观地确定了风口回旋区长度、以及喷吹煤粉燃烧率,对包钢高炉炉缸活性度研究以及提高煤粉的喷吹量研究有非常重要的指导作用。
4)  Changfeng Business District
长风商务区
5)  fetch width
风区宽度
1.
A note on forecasting formula for wind wave and fetch width;
关于风浪预报公式和风区宽度的注记
6)  length of light area
亮区长度
1.
The relationships among syrup concentration, refraction index, critical angle, length of light area and number of CCD unit in light area are mathematically described on the basis of general definition of supersaturation of syrup.
通过对糖浆浓度激光自动检测过程的机理分析,以糖浆过饱和度的一般定义为依据,对糖浆浓度与折射率、折射率与临界角、临界角与亮区长度以及亮区长度与像元数的关系等进行了数学描述,最后导出了测量过程的数学模型。
补充资料:变形区长度


变形区长度
length of deformation zone

  b ianxingqu ehangdu变形区长度(length of deformation:one) 轧制时轧件同轧辊接触弧的水平投影长度,一般以l表示,l=双sina,式中R为轧辊半径,a为咬入角。从几何关系还可以求得l与R及压下量从的关系为l /_.,从2,_劫2.__L___.,~~:,、,~=心R从一二笋.,由于岑~相对于R助小得多,故计算 V-一4’一一4’一’‘’--一一~一,一,·~中均用其近似值l、翻丫天瓦。 (余望)
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条