说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 振形
1)  Mode [英][məʊd]  [美][mod]
振形
1.
The relative curves between natural frequencies and spring coefficients were given, and the characters of modes were described.
数值上计算了具有弹簧支承0°和45°玻纤/环氧层合悬臂板的模态参数,给出了固有频率和弹簧系数间的关系曲线以及振形特征。
2)  circular corrugation
环形振纹
1.
Study on circular corrugation on turned face and its causing reasons;
车削端面环形振纹及其产生因素的探讨
3)  wave-vibration
波形振动
1.
According to food fluidization for freezing process existing problems,a new type of food quick freezer with wave-vibration and semi-fluidization was development,it is based the working characteristic of fluidized-quick-freezer, with the lower wind speed and the higher vibrant intensity,which realizes individually quick frozen.
综合分析了食品流化冻结时存在的问题及常规解决办法,从提高单位时间冻结量以及降低单位产品能耗的角度出发,研制了一种全新的波形振动半流化食品速冻机,采用较低风速度,较高振动强度,实现了单体快速冻结,减少了运行费用,提高了食品冻结质量。
4)  natural mode of vibration
固有振形
1.
Based on the instances of turning or grinding spindly shaft and the theory on tiny vibration ofelastomer, this paper educes the natural mode of vibration in the process of typically machining, analyzes its eff-ect on the formation of surface corrugation, puts forward the measure against surface corrugation.
本文依据车、磨细长轴实例和弹性体微振动理论,导出典型工艺下的固有振形,分析其对表面波度形成的影响,并提出了控制表面波度产生的措施。
5)  Vibration form
振动形式
1.
An analysis is made of an ideal vibration form in regard of a vibrating conveyer, and of its feasibility in practical engineering realization in this paper which also brings forth the method for designing the vibration system in purpose practice.
分析振动输送机理想振动形式在工程应用中的实际可行性,提出振动系统的设计实现方法,为振动输送机的设计提供了设计基础。
6)  vibration waveform
振动波形
1.
A lossless real-time compression algorithm for vibration waveform in steam turbine units;
汽轮机组振动波形数据高效实时无损压缩算法
2.
Aiming at the vibration brought tail-wagging of principal axis and the real-time display characteristics of vibration waveform and locus of journal center in vibration monitoring system for generating units,drawing dynamic curve by feechart was introduced under the circumstance of C++Builder 6.
针对发电机组振动监测系统中主轴高速旋转引起的振动,以及其振动波形和轴心轨迹的实时显示特点,介绍了如何在C++Builder 6。
补充资料:点振子振动和点电极振子振动
分子式:
CAS号:

性质:又称点振子振动和点电极振子振动。振动能量绝大部分集中在点电极范围内,形成“能量封闭”的振动模式。振子电极面远小于压电陶瓷片的总面积,且与厚度有适宜的匹配关系。在交变电场作用下,沿厚度方向产生振动,其振幅随着至电极中心距离的增加,呈指数式衰减。谐振频率与压电陶瓷片的厚度有关。为提高频率通常将压电陶瓷片磨得很薄,有时考虑到压电陶瓷自身强度太低,可用特制的陶瓷片作垫片来防止压电陶瓷片损坏。常用于高频场合。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条