1) crowd extrusion load
人群挤压荷载
1.
To simulate the vulnerable working conditions of APG under the applied load,place the substituted load equal to the wind load and the crowd extrusion load on the prototype of APG.
通过对屏蔽门样机施加等效风压荷载和人群挤压荷载,模拟屏蔽门受荷载作用下的不利工况。
2) extrusion load
挤压载荷
1.
The influence of the curvature angle ψ of the outside corner on the extrusion load and the deformation uniformity was discussed.
运用有限元方法对纯铝的等径弯角挤压(ECAE)过程进行了模拟计算,探讨了挤压通道外接圆弧角ψ对挤压载荷及试样变形均匀度的影响。
3) crowd load
人群荷载
1.
In this paper,based on comparison study of crowd load in some countrios,we give the reform towards the standard in present.
从国内外桥梁规范中对人群荷载的规定值作比较，提出应改进的地方并给出改进建议。
2.
The paper introduces calculation of crowd load and method of load combination on the long ring steel box girder bridge,it also discusses about confirmation size of cross section,temperature effect and frequency control of steel box girder bridge.
介绍了超长环形连续钢箱梁天桥人群荷载的计算及荷载组合方法,对钢箱梁截面尺寸的确定及温度作用与频率控制作了探讨,通过一些措施的实施,从而解决了对频率控制的不利影响。
4) External collapse load
外挤载荷
1.
Effects of cement sheath elastic modulus on casing external collapse load;
水泥环弹性模量对套管外挤载荷的影响分析
5) load-ram displacement curve
挤压载荷-行程曲线
1.
Experiments were conducted to achieve the load-ram displacement curves when polypropylene(PP) were processed by equal channel angular extrusion(ECAE) under different extrusion conditions.
对聚丙烯(PP)进行等通道转角挤压(ECAE)加工,利用电子万能试验机获得PP在不同挤压工艺参数下的挤压载荷-行程曲线,根据其宏观剪切变形情况,分析了在ECAE加工过程中挤压载荷的变化规律;并分析了挤压工艺参数对PP屈服载荷的影响。
补充资料：冲击挤压(见冷挤压)
冲击挤压(见冷挤压)
impact extrusion
ehongji jiya冲击挤压(impaet extrusion)见冷挤压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条