1) withdraw force
脱模力
1.
The effects of impact energy and compaction methods on the green density,the maximal impact force,the withdraw force and the radial springback were discussed.
采用高速压制技术制备铁基制品,探讨了冲击能量及冲击速度与冲击行程之间的关系,并研究了冲击能量、压制方式对生坯密度、最大冲击力、脱模力和径向弹性后效的影响。
2.
The effects of impact energy and impact times on the green density, the maximal impact force and the withdraw force of specimen were investigated.
研究电解铜粉高速压制成形工艺,探讨冲击能量、压制次数对生坯密度、最大冲击力和脱模力的影响。
3.
The effect of compacion velocity on green density,maximal impact force,withdraw force and radial springback was studied,and the top and bottom microstructures of specimens were observed.
本文采用模壁润滑和高速压制相结合工艺在HYP35-7型高速压机上成形Fe-2Cu-1C铁基粉末,研究压制速度对生坯密度、最大冲击力、脱模力和压坯的弹性后效的影响,并分析了压坯的显微组织。
2) ejection force
脱模力
3) stripping force
脱模力
1.
Based on model test of shutter with single contraction end and data processing, mechanism of shutter stripping, and factors affecting the stripping force are described.
通过单收缩口模型模板的试验和数据的处理分析，阐明了模板脱模机理，决定了影响脱模力大小的因素，推导出脱模阻力计算公式，为模板设计工作提供了依据。
2.
The blocking resistance of the coatings was investigated by the tests of contact angle,stripping force and the adhesion.
采用测试疏液角脱模力及表面粘结力的方法研究氟碳复合涂料的耐粘性,结果表明改性微粉和助剂的加入,显著增强了FEVE涂料的耐粘性。
4) ejecting pressure
脱模压力
5) ejection resistance
脱模阻力
1.
China s injection mouldings have been increasing in weight and empirical estimate of ejection resistance has to be replaced with calculated estimate.
讨论了一般情况下脱模阻力计算公式的简化，引入了两个简化系数。
6) force demoulding
强力脱模
补充资料：赤力力
1.亦作"赤历历"。 2.象声词。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条