1) interlaminar shear stress
层间切应力
2) interlaminar shear stress
层间剪切应力
1.
The results showed that the crosssectional width of tire,the interlaminar shear stress in cord plies of bead area,and the first principle stress and strain in cord plies increased,but the overall diameter of tire and the maximum v.
结果表明,随轮胎胎体帘线角度的增大,轮胎断面宽、胎圈部位帘布层的层间剪切应力、胎体帘布第一主应力及第一主应变增大,而轮胎外直径、最大垂直接触应力及最大摩擦应力减小。
3) Interlaminar stresses
层间应力
1.
Numeric analyses for interlaminar stresses of the free corner effect in laminates;
层合复合材料自由角附近层间应力场的数值分析
2.
The interlaminar stresses and experiment research of viscoelastic laminated plates for damping vibration;
粘弹层合板阻尼振动的层间应力和实验研究
3.
Damping vibration and interlaminar stresses of submarine pressure hull with anechoic tile in fluid;
带有消声瓦的潜艇耐压壳在流场中的阻尼振动和层间应力
4) interlaminar stress
层间应力
1.
A simplified model for interlaminar stress analysis of bridge asphalt pavement;
桥面沥青铺装层间应力分析简化模型
2.
Numerical analysis of sandwich plate′s interlaminar stress;
夹层板结构层间应力数值分析
3.
The interlaminar stresses at different interface of thick angle ply AS4/PEEK laminates are computed, the three dimensional distribution characters of the interlaminar stresses on the individual interfaces are analyzed .
计算了厚的AS4 /PEEK角铺设层合板[±25]s4在不同界面上的层间应力。
5) interlayer stress
层间应力
1.
The reason of interlayer stress and warpage deformation are analyzed in this paper.
分析了层间应力及翘曲变形产生的原因,并在一定的假设条件下,得出了层间应力的计算公式及其在截平面上的分布情况。
2.
Because the elastic modulus of interlayer concrete usually waves during its construction period,we developed three sets of elastic module and two different dam height and used the reciprocal equal theorem of shear stresses to calculate the changes of RCC interlayer stresses under the conditions of different dam height .
由于实际施工时,层间混凝土弹性模量经常波动,为此,拟定3组弹性模量及两种不同坝高,利用剪应力互等定理计算得到不同坝高、不同弹性模量碾压混凝土层间应力的变化情况,通过分析变化曲线得出,层间弹性模量相对于碾压混凝土本体弹性模量越小,坝下游部位应力集中越严重。
3.
The interlayer stress transferring characteristics will affect the reflection of sensor to the actual strain of measured structure.
埋入被测体内部的光纤传感元的应变是靠结构基体到裸光纤的层间应力传递作用产生的,各层材料间的应力传递特性直接影响传感元对基体真实应变的反映程度。
6) shearing strength between layers
层间剪切力
1.
Results show that temperature turns out to be the most significant factor influencing the shearing strength between layers,next comes the diameter of bestrewed detritus,next but one is the thickness of paved ply,while the influence of.
结果表明温度对层间剪切力的影响最大,其次是撒布碎石粒径,再次是铺设厚度,而防水材料的影响最小。
补充资料：等效切应力
等效切应力
equivalent shear stress
dengxlaoq一eyingll等效切应力(equivalent Shear stress)一般应力状态下的各应力分量经适当组合而形成的与纯剪切应力等效的应力，也称统一切应力，切应力强度。其表达式为一六寸(一，2+(一，2+(一)2 等效切应力与偏应力张量二次不变量(见应力张量)的关系为二一了，万，与八面体切应力二(见八面体应力)仅差一常系数，与坐标轴变换无关。 (王占学)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条