1) billet structure
铸坯组织
1.
This paper analyses effect of controlling thermal resistance interface of billet hardening, mould heat transfer conditions and cast billet structure on product quality in SCR continuous casting and rolling process for producing copper-silver alloy conducting wires.
分析了SCR连铸连轧工艺生产铜银合金导线时,铸坯凝固的热阻界、铸模的传热条件、铸坯组织的控制对产品质量的影响。
2) as-cast microstructure
铸态组织
1.
Morphology and Phase Constituent of Secondary Phase in As-cast Microstructure of 7150 Aluminum Alloy;
7150铝合金铸态组织中第二相的形貌及相组成
2.
Effects of Trace Si,Ba and Sn on the As-cast Microstructure of AZ91 Magnesium Alloy;
微量Si、Ba、Sn对AZ91铸态组织的影响
3.
Effect of lithium on as-cast microstructure of Mg-2Al-1Zn-4Y-3Nd alloy;
Li含量对Mg-2Al-1Zn-4Y-3Nd合金铸态组织的影响
3) As-cast structure
铸态组织
1.
On the basis of twin-roll thin strip continuous casting experiments, structure and composition analysis, the as-cast structure characteristics of 1Cr18Ni9Ti stainless steel twin-roll thin strip were investigated.
通过双辊薄带连铸试验和组织成分分析,对1Cr18Ni9Ti不锈钢双辊薄带的铸态组织特征进行了研究。
2.
The effect of yttrium on as-cast structure and age hardening of the magnesium alloy Mg-9Al-1Zn were investigated.
研究了稀土元素钇 (Y)对Mg 9Al 1Zn合金铸态组织及时效硬化特性的影响。
3.
The investigation was carried out experimentally on as-cast structure evolution of horizontal continuous casting aluminum alloy under combination electromagnetic field.
采用试验的方法研究了组合磁场作用下5182铝合金水平连铸过程中铸态组织的演变。
4) post-casting structure
铸后组织
5) cast microstructure
铸态组织
1.
Effect of N on in-cast microstructure and mechanical properties of Ti-6Al alloys;
氮对Ti-6Al合金的铸态组织与性能的影响
2.
As-cast microstructure and mechanical properties of Ti-N alloys;
钛氮合金的铸态组织与性能
6) cast structure
铸态组织
1.
The cast structures and component of vacuum melten and rapid solidified Cu-15Ni-8Sn alloys without Si or with different addition levels of Si (0.
2%)的Cu-15Ni-8Sn合金的铸态组织形貌及构成进行了研究。
2.
The cast structure and component segregation were studied in Cu 15Ni 8Sn with addition of Si by optical microscope, SEM and energy spectrum analysis.
用金相、扫描电镜及电子能谱微区成分分析等方法对添加少量Si的Cu 15Ni 8Sn合金的铸态组织结构及成分偏析进行了研究。
3.
50 %, mass %) of mischmetal on cast structure and hardness of Al 7Si 4Cu alloy is studied by using metallographic analysis,electronmicroscope and thermal analysis.
５０％，质量分数）对Ａｌ－７Ｓｉ－４Ｃｕ合金铸态组织与硬度的影响。
补充资料：衡阳钢管厂水平连铸机生产连铸圆管坯
衡阳钢管厂水平连铸机生产连铸圆管坯
衡阳钢管厂水平连铸机生产连铸圆管坯
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条