1) extrusion load
挤压载荷
1.
The influence of the curvature angle ψ of the outside corner on the extrusion load and the deformation uniformity was discussed.
运用有限元方法对纯铝的等径弯角挤压(ECAE)过程进行了模拟计算,探讨了挤压通道外接圆弧角ψ对挤压载荷及试样变形均匀度的影响。
2) crowd extrusion load
人群挤压荷载
1.
To simulate the vulnerable working conditions of APG under the applied load,place the substituted load equal to the wind load and the crowd extrusion load on the prototype of APG.
通过对屏蔽门样机施加等效风压荷载和人群挤压荷载,模拟屏蔽门受荷载作用下的不利工况。
3) External collapse load
外挤载荷
1.
Effects of cement sheath elastic modulus on casing external collapse load;
水泥环弹性模量对套管外挤载荷的影响分析
4) load-ram displacement curve
挤压载荷-行程曲线
1.
Experiments were conducted to achieve the load-ram displacement curves when polypropylene(PP) were processed by equal channel angular extrusion(ECAE) under different extrusion conditions.
对聚丙烯(PP)进行等通道转角挤压(ECAE)加工,利用电子万能试验机获得PP在不同挤压工艺参数下的挤压载荷-行程曲线,根据其宏观剪切变形情况,分析了在ECAE加工过程中挤压载荷的变化规律;并分析了挤压工艺参数对PP屈服载荷的影响。
6) cut-in load
压入载荷
1.
Through analysis it is concluded that for a given rock and given tooth profile,the cut-in displacement(depth)is in a linear relationship with cut-in load,the volume of breaking pit decreases with t.
对试验结果进行分析,得到了围压作用下对于所试验的岩石和齿形,压入载荷和压入位移成线性关系;岩石破碎坑的体积随压入载荷的增加而减小;在以相同齿形压入相同岩石的条件下,岩石的破碎面积和体积随围压的增加而减小。
补充资料：冲击挤压(见冷挤压)
冲击挤压(见冷挤压)
impact extrusion
ehongji jiya冲击挤压(impaet extrusion)见冷挤压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条