1) Gear extrusion
齿轮挤压
1.
Stream surface modeling for the gear extrusion mould cavity;
齿轮挤压成形型腔流曲线曲面造型
2) cold extrusion of gears
齿轮的冷挤压
3) extrusion cam
挤压凸齿
4) extrusion wheel
挤压轮
1.
It is very difficult to determine precisely the distribution of the stresses in concave-grooveof extrusion wheel．By using the theory of complex function of elastic mechanics，a new calcu-lating method about stresses in concave-groove is presented． The effect of the stresses con-centration which is relevent to the geometric parameters is given.
应用弹性力学的复变函数理论对连续挤压机挤压轮的轮槽应力进行了分析计算，指出了轮槽主要多数对应力集中的影响，这对挤压轮的失效分析和设计具有重要的指导意义。
2.
The causes of extrusion wheel fracture was analyzed by optical direct reading spectrometer,optical microscope and scanning electron microscope(SEM).
利用直读光谱仪、光学显微镜和扫描电镜等检测仪器,分析了挤压轮的材料化学成分、断口形貌以及显微组织情况。
补充资料：冲击挤压(见冷挤压)
冲击挤压(见冷挤压)
impact extrusion
ehongji jiya冲击挤压(impaet extrusion)见冷挤压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条