1) deep well lifting
深抽工艺
1.
Design and appraisal of horizontal wells deep well lifting technology;
水平井有杆泵深抽工艺的设计与评价
2) Extraction technology
抽提工艺
1.
Full-factor-test method is used in this paper to study the influence of extraction technology on its wood in order to suppress its shrinkage.
为了抑制桉木干缩,采用全因子试验方法研究抽提工艺对尾巨桉木材干缩性的影响。
4) drawing process
拉深工艺
1.
The hot drawing process for the sheet of AZ31 magnesium alloy was discussed.
主要研究了镁合金热拉深工艺过程中,各工艺参数包括拉深温度、压边间隙、润滑条件、拉深速度等对镁合金拉深成形性能的影响。
2.
In the article,the tube drawing process design system that uses AutoCAD2006 as a platform is developed by the tool of VBA.
以AutoCAD2006作为平台,用VBA为工具开发了筒形件的拉深工艺设计系统。
3.
The forming process of variable cross-section spiral-shaped was studied, and the key factors which affect the drawing process were synthetically discussed mainly including the drawing system parameters, the size of the blank and cavity of mould.
采用多道次高温拉深工艺,坯料周边余量留取15mm,坯料圆弧与直线交接部位开取合适的工艺缝,模具设计中型腔尺寸缩量5%,在此工艺参数下试制的蜗壳件形状尺寸可较好的满足实际使用要求。
5) Drawing Technology
拉深工艺
1.
The Drawing Technology for the Shell of Clutch and Design of the Die;
离合器外壳拉深工艺及模具设计
2.
The drawing technology for CM sleeve barrel was analyzed.
分析了CM套筒的拉深工艺,介绍了级进模的结构及特点,对模具和夹具的相互运动过程进行了说明。
3.
In this paper,the drawing technology of the toolbox rectangular part was analyzed,the dimensions and shape of the blank were calculated,the drawing times and dimensions of the part were determined,the structure design of the blanking-drawing compound die for the part was introduced.
分析了工具箱矩形件的拉深工艺,计算了矩形件的毛坯形状及尺寸,确定了拉深次数及其工序尺寸,介绍了工具箱矩形件落料-拉深复合模结构设计。
6) deep-dyeing process
增深工艺
补充资料：抽抽趔趔
1.犹言别别扭扭。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条